2011 Gmc Sierra Crew Cab Side Steps 20'' Wheels 12k Mi Texas Direct Auto on 2040-cars

Auto blog

NHTSA investigating nearly 750,000 GM models over non-deploying airbags

Nearly 750,000 vehicles built by Chevrolet, GMC, and Cadillac are the subject of a National Highway Traffic Safety Administration (NHTSA) investigation due to non-deploying driver-side airbags. While the investigation is ongoing, the agency believes the issue is likely due to rust particles that form on the inflator's connection terminal interface. The list of nameplates included in the investigation includes Chevrolet's Silverado, Tahoe, and Suburban, GMC's Sierra, Yukon, and Yukon XL, plus Cadillac's Escalade, Escalade ESV, CT4, CT5, and XT4. All of the potentially affected vehicles are 2020 or 2021 models, according to a bulletin published on the NHTSA's website. Investigators launched the probe in April 2021 after 15 consumers reported airbag-related issues, including nine who said an airbag malfunction light appeared in the instrument cluster. More alarmingly, the NHTSA is aware of six accidents that caused significant damage to the car's front end yet didn't trigger the driver's airbag. It adds that there are no fatalities linked to the issue, but there are six crashes and eight injuries reportedly blamed on it. No evidence suggests this problem is related to the millions of potentially deadly Takata inflators recalled over the past few years. General Motors is aware of the defect. It sent a technical service bulletin (TSB) to its dealers in March 2021 to address the aforementioned warning light. The note explains the issue is due to "rust particles in the connection terminal interface of the driver's airbag inflator." The company hasn't issued a safety recall yet, however. Whether it will partially depends on the NHTSA's findings. It's currently looking into the scope and the severity of the problem, and it wants to understand its implications on driver safety. Investigators will decide whether General Motors needs to recall the 749,312 cars that are part of the probe when they close their investigation. General Motors has already spent a significant amount of money replacing defective airbag-related parts in its cars. In November 2020, it was ordered by the American government to recall nearly 6 million pickup trucks and SUVs equipped with potentially dangerous Takata airbag inflators. It repeatedly argued that testing proved the inflators were safe, and it petitioned the agency four times starting in 2016 to avoid a recall, which cost an estimated $1.2 billion (about a third of its net income in 2020).

Next-generation GMC Canyon, Chevy Colorado spied together

With the debut of the next-generation GMC Canyon coming in a couple of months (in off-road-ready AT4 guise no less), it's no surprise that both it and the Chevy Colorado are out testing without the heavy coverings of early prototypes. One of our spy photographers caught examples of both trucks with close-fitting vinyl wraps. This gives us a great opportunity to see each pickup more clearly, but also to compare and contrast the designs. From the front, the GMC features a narrower, but seemingly taller grille. At the top are slender lamps. They seem to be daytime running lights, though, and below them are much larger units that will function as the actual headlights. The prototype shown seems to be one of the AT4 variants, based on the lack of a lower air dam and the opened up corners of each bumper. Small fog lights show up in the lower bumper, too. As for the Chevy, its grille is wider, and it blends into the headlights. The lights are at the top of the grille, and they seem to incorporate the actual headlights, not just running lamps. The grille mesh has some interesting detailing, and there are auxiliary lights below the main headlights. This one seems to be a more mainstream Colorado model since it still has a front air dam, possibly a Z71 model, considering the chunky tires. Not surprisingly, the two trucks are very similar from the sides and the rear. They have cabins that look lower, longer and more squared-off than the current models. The fenders look more punched out and aggressive, too. The main differentiator between the Chevy and GMC are the wheel openings. The GMC has sharp corners and the Chevy has more rounded ones, as is the case with the full-size trucks. As previously mentioned, the GMC Canyon AT4 will be revealed this summer, so likely in just a month or two. The Colorado will likely be revealed this summer, too. It's expected that it will use the turbocharged 2.7-liter four-cylinder shared with the Silverado. Naturally, it will be available with two- and four-wheel drive and a variety of trim levels including the AT4 and ZR2 off-road versions. Related video:

Chevrolet considering midsize crossover to slot between Traverse and Equinox

Crossovers are the new hotness, and automakers are looking to cash in by offering a size and shape for every customer. With Chevrolet's debut of the new 2018 Traverse in Detroit, which grew ever so slightly compared to the first-generation model, there is now a midsize-crossover-sized hole between the three-row Traverse and the compact Equinox. When asked about that obvious space, a Chevrolet spokesperson told us the company is looking into the possibility of expanding its crossover lineup. It should be a relatively simple thing to do, since all it would take is reskinning and rechristening the GMC Acadia with a bow tie, and we all know how much GM loves platform sharing. Although they're now different sizes, the new Acadia and Traverse still use the same platform; the Acadia is now on a short-wheelbase version of the C1XX while the Traverse uses long-wheelbase C1XX parts. A short-wheelbase Chevy built on the C1XX likely would be differentiated visually from both the Acadia and the larger Traverse. It may seem like flooding the lineup with more and more models would cannibalize sales of existing ones, but Chevrolet said it would rather have customers stay within the brand rather than going to another automaker. There have been whispers that some form of the Blazer name (possibly TrailBlazer) may make a return on a midsizer, but if it does don't expect an old-school body-on-frame SUV like the old one. In the end, if Chevy builds it, customers will come. Related Video: