2000 Gmc Sierra on 2040-cars

Auto blog

GM Ultium tech can scavenge heat from everywhere, even you

GM likes to give us tidbits about its Ultium platform from time to time, and today it’s telling us about the platformÂ’s ability to capture waste heat from the propulsion system. In addition to capturing from the propulsion system, it can also capture humidity from both inside and outside the vehicle and even from passengersÂ’ body heat. Yes, you, your family and/or your friends are a usable heat source as far as GM EVs are concerned. It then deploys the heat in an advantageous way. If at this point, youÂ’re screaming, "Heat pump!" youÂ’d be right. WeÂ’re talking about an elaborate heat pump system that GM is using for its Ultium-based vehicles. Every Ultium-based GM vehicle gets this system that is covered by 11 patents and four publications. The waste heat it collects is used in a number of ways, but its primary use is to heat the cabin quickly and efficiently. GM claims it can heat the cabin of its Ultium-based vehicles quicker than vehicles with traditional internal combustion engines. Plus, when put to use, GM claims that using the heat pump provides its EVs with up to 10% more range than theyÂ’d have without. Beyond heating the cabin, the heat pump is capable of putting waste heat to use by preheating the battery prior to charging so that you can charge quicker. The system can even cool the propulsion system in preparation for Watts to Freedom (WTF) launch control starts. GM says this was vital in helping the Hummer EV achieve its bonkers 0-60 mph time of about 3 seconds. “Having a ground-up EV architecture gives us the freedom to build in standard features like UltiumÂ’s energy recovery capabilities,” said Doug Parks, GM executive VP of global product development, purchasing and supply chain. “This helps us squeeze more efficiency, performance and overall customer benefit out of our EVs.” GM says itÂ’s been developing heat pump technology since the EV1 and its heat pump. This is the modern evolution of that technology, and GM says itÂ’s going to be implemented in every Ultium-based vehicle as a standard feature. Related video: Green Cadillac Chevrolet GM GMC Technology Electric Future Vehicles

GMC Syclone spools up a storm on Jay Leno's Garage

A storm was brewing on American roads in the early 1990s. That's when Detroit's automakers were producing some of the hottest performance trucks ever devised – models like the Ford Lightning, GMC Typhoon, and its flyweight pickup sibling, the GMC Syclone. Jay Leno just happens to have one of the latter in his garage, and took it out to showcase in this latest video segment. The Syclone was an exercise in absurdity, and could not only trounce any other pickup on the road, it could outrun anything else GM made and just about anything else on the road – beating Ferraris and Porsches off the line. In a pickup, for crying out loud. The kicker is that its engine wasn't such a monster, either: under the hood sat a 4.3-liter turbocharged V6 pumping out what would seem by today's standards to be an adequate 280 horsepower and 350 pound-feet of torque. Even the smaller of the EcoBoost V6s available in today's Ford F-150 produces more than that. But in a lightweight, compact pickup, those figures were enough to propel the Syclone to 60 in 4.3 seconds and run the quarter-mile in 13.6 seconds. Long before the dune-jumping Ford F-150 SVT Raptor or even the Viper-powered Dodge Ram SRT-10, GM made fewer than 3,000 Syclones based on the compact Sonoma (sister to the Chevy S-10) and another 4,700 of the Typhoon, which was mechanically similar but more practical (albeit heavier) wagon bodywork from the Jimmy. But as Jay aptly points out, the Syclone was the one you wanted. Scope it out in the ten-minute video clip above.

2022 GMC Yukon AT4 to offer 6.2-liter V8

A year ago, GM said it was considering making its 6.2-liter V8 available outside the flagship trims of its full-sized SUV trio of Chevrolet Tahoe and Suburban, and GMC Yukon. There has been a year of gnashing teeth on GM forums since the automaker decided to meditate on the issue, but GM Authority reports The General has finally made the call — the 2022 Yukon AT4 will offer the 6.2-liter. This follows last week's news that three 2022 Chevrolet Tahoe and Suburban trims would also add the 6.2-liter as an option. With the Yukon Denali already in the 6.2-liter camp, only the Yukon SLE and SLT will be left out. Those latter two levels will continue to offer the 3.0-liter Duramax diesel as the optional engine, which the AT4 trim cannot take advantage of because the AT4's front fascia and skid plate interfere with the diesel's plumbing. The 5.3-liter V8 that's the standard engine makes 355 horsepower and 383 pound-feet of torque. The 6.2-liter makes 420 hp and 460 lb-ft. As has been pointed out, the 5.3-liter can tow 200 pounds more than the 6.2, but fuel economy is a wash — the 5.3 only gains 1 mpg in the city over the 6.2. This is a pure power play. For the moment, it looks like Yukon AT4 buyers won't need to do anything other than check a box to get the 6.2-liter. That's the opposite of what some Tahoe and Suburban buyers will face when trying to get the 6.2-liter for their rigs; outside of the Premier trim, Chevy put the engine behind a paywall of option packages. Since GMC hasn't revealed pricing for the 2022 lineup yet, we don't know what the surcharge will be for the big engine. The GMC Sierra AT4 pickup charges $2,195 to go from the 5.3 to the 6.2, so that's probably in the ballpark. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.