Gmc Canyon 4wd Ext Cab 125.9" Sl Low Miles 2 Dr Truck Manual Gasoline 2.9l Dohc on 2040-cars

Auto blog

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video:

GM recalls 3,300 pickups and SUVs for new ignition-switch issue [UPDATE]

UPDATE: A statement from GM about the recall has been added below. The exact total of vehicles affected is 3,296, including 3,073 of them in the US. General Motors isn't letting an ignition-switch problem grow into a massive scandal again. The automaker is recalling about 3,300 North American trucks and SUVs. They are: the 2014 Chevrolet Silverado and GMC Sierra and the 2015 Chevy Suburban and Chevy Tahoe, as well as 2015 model heavy-duty pickups, the Detroit News reports, citing an Associated Press story. The issue appears to have been caught fairly quickly. In this case, the keys can get stuck in the "start" position and then slip to "accessory" if bumped. This is because the ignition lock gears have an outer diameter that's larger than the specifications allow. When that happens the engine shuts off, and the driver loses assistance to the steering and brakes. The airbags might also be affected. The vehicles get a new ignition-lock housing to fix the problem. According to the Detroit News, an employee who experienced the problem with the switch discovered the issue, and this person then let officials at the automaker know as part of the Speak Up for Safety program. A total of five reports of the fault were discovered. However, there are no cases of injuries or crashes. The claims to the automaker's resolution program eventually tallied that GM's previous ignition switch problem included 124 deaths and 275 injuries. The company also had to recall millions of vehicles and pay significant fines to the US government. GM Statement General Motors is recalling 3,073 full-size trucks from the 2014 and 2015 model years in the U.S. Some of these vehicles may have an ignition lock actuator gear with an outer diameter that exceeds specifications, which may make turning the ignition key difficult. The ignition key could get stuck in the "start" position. This may be more likely at higher interior ambient temperatures. If the vehicle is driven with the key stuck in the "start" position, and the vehicle experiences a significant jarring event or the vehicle's interior temperature cools, the ignition lock cylinder could move out of the "start" position, rotate past the "run" position, and move into the "accessory" position, leading to loss of power steering assist, power brakes and potentially air bag deployment in certain crashes. Dealers will replace the ignition lock housing.

2020 Chevy and GMC HD truck spy shots reveal LED lighting

With Chevy and GMC's 1500 series pickups just starting to roll into dealerships, our attention naturally turns to the Heavy Duty 2500 and 3500 series trucks. We've seen these HD trucks testing already, but thes latest spy photos give us our first good glimpse of the two HD trucks' headlights through some translucent camouflage, and their designs appear very interesting and quite different from each other. The 2020 Chevrolet Silverado HD looks to be getting a striking set of LED lights that flank the grille. A previously released teaser image of the truck shows that the front lighting elements are split by a bulky wing that branches out from a big, upright chrome face, and both top and bottom units seem to incorporate LED slashes. If you look closely at the images, you can easily make out the Chevrolet script cut into the grille's top edge. Amidst a bevy of Chevy test trucks was one lone GMC model in a dually configuration, and the Sierra HD also appears to have some LED accent lighting up front. Unlike the boomerang-shaped Chevy LEDs, GMC's version sports a shoulder-like right angle of light bars. Assuming these are production-level lighting units, it seems the Sierra HD will stick pretty close to the face of GMC's latest light-duty pickup truck. We're still waiting for confirmation on what range of powertrains will be available in GM's next-gen HD trucks, but we're sure there will be both gasoline- and diesel-burning engines on the ordering sheet. We expect to hear official details on the trucks sometime soon. Related Video: Featured Gallery 2020 GM Heavy Duty Pickup Spy Photos View 18 Photos Image Credit: KGP Spy Photography Spy Photos Chevrolet GMC Truck gmc sierra hd chevy silverado hd