10 Ford Transit Connect Xlt - 1 Owner Florida Van - Original Paint- No Accidents on 2040-cars

Auto blog

Why Edmunds took a sledgehammer to its 2015 Ford F-150

The discussion around repair bills for the aluminum-bodied 2015 Ford F-150 pickup continued from the beginning of last year to the end, and haven't abated; as an aside, some Tesla Model S owners have been shocked at disquieting repair estimates for minor damage to their aluminum wunder-sedans. Edmunds decided to inject some fact into the fray: it bought a $52,000 long-term 2015 F-150 and clouted it with an eight-pound sledgehammer. Twice. The rear of the bedside took the impacts since it couldn't be replaced, it would have to be repaired. To the pickup's credit, the only reason associate editor Travis Langness hit it twice was that the first sledgehammer blow didn't do as much damage as Edmunds wanted. After the second, the visible damage included the two direct impacts, a few creases, and a cracked taillight, so they drove the pickup to Santa Monica Ford to get an estimate, complete with a fictitious story about how the damage occurred and the mercy plea that Langness was paying for the repair out-of-pocket. In Part 2 Langness hits on some of the details with getting the truck fixed, such as the massively expensive taillight and the list of tools Ford recommends dealers have to work on aluminum. But he was promised he'd have his truck back in seven days, and Santa Monica Ford got it back to him in seven days. In Part 3 we get the bill. It's not small, but it's quite a bit less than it could have been if the service manager had charged Edmunds the official labor rate for aluminum. We're not going to spoil it here, so check out the videos above and below for the beginning and the end, and head over to Edmunds for the complete story about how it all happened and some riffing on the repair numbers. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Related Video:

NHTSA investigating Ford Fiesta for faulty door latches

The National Highway Traffic Safety Administration has opened a preliminary investigation on the 2011-2013 Ford Fiesta because the regulator has received 61 complaints from drivers, including one claim of an injury, about the doors on the subcompacts failing to latch and sometimes even flying open while driving. NHTSA has estimated that the problem could affect as many as 205,000 vehicles.
NHTSA is still gathering further data about the problem, but looking at the complaints so far, both front and rear doors appear to be potentially involved with the alleged failures. Among the reports, there are 12 claiming that the door opened while driving. Several also indicate the "Door Ajar" warning illuminating during this problem. The one purported injury happened when someone attempted to shut the door, and it bounced back.
Ford spokesperson Kelli Felker told Autoblog via email, "We are cooperating with NHTSA on this investigation, as we always do." Scroll down to read the report from NHTSA.

Ford extends shutdown, Stellantis confirms layoffs due to chip shortage

Ford and Stellantis this week announced new production cuts due to the global semiconductor shortage, with popular models including the Ford F-150 and Jeep Grand Cherokee facing cuts. Stellantis plans to temporarily lay off workers at one facility as production is curtailed.  According to Automotive News, Ford is extending shutdowns at some of its North American facilities into May. The Blue Oval has been forced to reduce or idle production of both its redesigned F-150 pickup and the popular Explorer due to the chip shortage. The Mustang, Transit, Edge, Lincoln Nautilus and Aviator will also continue to be affected. Stellantis is planning to temporarily lay off workers at a Jeep plant in Detroit during April and May due to a shortage of semiconductor chips. The company will cut two work crews at its Jefferson North plant in Detroit for three weeks starting April 26, then call them back and lay off a third crew from May 17 through the week of May 31, according to a schedule obtained by Bloomberg News. The plant on Detroit’s east side normally operates two shifts with three work crews six days a week to keep it running 20 hours a day. “Stellantis continues to work closely with our suppliers to mitigate the manufacturing impacts caused by the various supply chain issues facing our industry,” company spokeswoman Jodi Tinson said in a statement. “Due to the unprecedented global microchip shortage, Jefferson North will adjust its production schedule through the end of May.” Jefferson North employs about 4,800 hourly workers and makes the Jeep Grand Cherokee, the top-selling Jeep model last year, and the Dodge Durango SUV. A redesigned version of the Grand Cherokee is scheduled to start production in August, according to researcher AutoForecast Solutions. This article contains reporting from Bloomberg. Plants/Manufacturing Ford Jeep Lincoln Technology chip shortage