1975 Thunderbird 20th Anniversary Copper Edition on 2040-cars

Auto blog

2014 Ford Mustang GT

I was more than a year removed from my last experience with the Mustang GT and its delicious 5.0 V8 when this new 2014 example rolled up to my driveway recently. Good weather and a planned road trip across the state meant that I would get plenty of seat time in this conservatively specified example, too. In total, I logged about 400 miles in a week of driving - not a lot for some of you super commuters out there, but quite a lot for this work-from-home journalist.
The basic formula of the 5.0 has stayed the same for 2014. The 2013 model year saw a number of updates to keep the Mustang fresh until it's replaced with an all-new generation for 2015. So, for its bon voyage tour, the fifth-generation Pony Car has seen only a few modifications: a couple of new paint colors (Oxford White and Ruby Read Metallic), trim and wheel revisions and, sadly, the deletion of the Boss 302 from the Ford lineup. However, while the limited-edition Boss is likely to reappear sometime after the gen-six Mustang makes its debut in 2015, the GT Track Package cars like the one I tested provide at least a partial solution for those looking for hot laps.
Driving Notes

Ford opens the doors on its Swedish rally skunkworks

It's always amazing to see how different kinds of racecars are made. Formula One racers are often constructed in modern architectural marvels that hint at some of the cutting-edge technology going into the racing. Conversely, rallying is all about sliding around on a varied course as fast as possible, but it often leaves a vehicle caked in mud. So it makes some sense Olsbergs MSE, or simply (OMSE) rally car shop in Nynashamn, Sweden, shows technological sophistication in a more down-to-earth setting. It builds Ford Fiesta ST racers for Global Rallycross there, and this new video gives viewers a tour through the work.
Former rally driver Andreas Eriksson runs OMSE. These days instead of racing, he and the company's 46 employees are building Ford racers from scratch. A ton of work goes into constructing each one, and according to Eriksson, it takes 400 hours to complete each body. At times, things are so busy that some of the technicians live in the shop in apartments that are on premises. There's even a restaurant to keep them fed. Sadly the dyno room is empty during this visit, though.
By the time OMSE is done, a rallycross car might resemble a Fiesta ST on the outside, but as you see in the video, it's a completely different beast underneath. Check out the work it takes to build one of them, and scroll down to read more about it in the official release.

Aussie Ford Falcon GT shows its rear end to Lamborghini Gallardo

When Ford Australia announces, as it did recently, that it wants to celebrate the end of its Ford Performance Vehicle division with a Falcon FPV GT-F that celebrates big-bore origins of the nameplate, it's talking about the kind of car in this video.
At some point the classic Falcon GT - said to be an XY series - was invited to a test of acceleration against a Lamborghini Gallardo. At the very least, the Falcon GT had a 351 cubic-inch motor and 300 horsepower, but whatever this guy's got under the hood of his yellow sedan makes has him so confident that he doesn't even move his elbow from its resting place on the door.
You'll find a reminder of Ford Australia's heyday, a raucous exhaust note and some NSFW language in the short video below.