Florida 2010 Ford Taurus Sel Heated Leather Sunroof Sony Xm Bluetooth Push Start on 2040-cars

Auto blog

Ford Fiesta ST GRC Racecar is hungry for podiums in 2013

As we reported earlier, the Chicago showing of this plucky Ford Fiesta ST GRC racer points to bigger and brighter days for Global RallyCross. For the upcoming season, you can expect to see Ken Block and Tanner Foust both driving the Ford racecar, and if last season's results are any indication, you can anticipate quite a few podium appearances, as well.
The Fiesta seen here was built by the Swedes at OlsbergsMSE, and will be driven in anger by Foust in 2013. Modifications are, as you'd expect, extensive, and include an engine, exhaust and braking upgrades, a racing style short-throw shifter and a limited-slip differential. As you can see, the car has been fully stripped out and caged for maximum speed and safety, too.
Refresh your memories with the details of the car, in the press releases below. And if you head out to the Chicago Auto Show this year, don't forget to drop by the Ford stand to have a look.

Ford to spread all-wheel drive across performance range

Car and Driver took a closer look at the all-wheel-drive system in the Focus RS, Ford reps having made "broad hints" about it being applied to other performance vehicles. One spokesperson even said that he "can see this as one of those technologies of the future." That would make sense because, as C/D notes, it couldn't have been an inexpensive job to engineer the torque-vectoring unit for the Focus – one that can send 70 percent of torque to the rear wheels, and send 100 percent of that portion to either wheel if needed. C/D also clues into the system's close similarity to the AWD unit in the recently updated Range Rover Evoque, which is manufactured by Sweden's GKN Driveline. In the Evoque, torque vectoring is brake based and two electronically controlled clutches turn the Range into a front-wheel-drive crossover under 22 miles per hour. Ford wouldn't comment on the GKN Driveline connection, or even if there is one. No matter where it might come from, more performance Fords are good for every enthusiast, and we do not look an AWD, torque-vectoring gift horse in the mouth. Featured Gallery 2016 Ford Focus RS News Source: Car and Driver Ford Technology Hatchback Performance

A cool boost to turbocharger performance

Since the advent of the forced-induction engine, we have been looking for ways to get every drop of performance we can. There are many approaches to getting additional power using better intercooling, water injection, or even adding nitrous oxide. One take on a short instant burst of power is being researched by Mahle and involves providing supercooled air to an engine, which allows it to burn a leaner fuel mixture and produce more power. The supercooling idea is not new and was examined by Ford in 1993 on the Mustang Mach III concept car, then brought up again in 2003 with the SVT F-150 Lightning concept. Ford called its system the SuperCooler; it was designed to work with any turbocharged or supercharged engine equipped with a water-to-air intercooler. The system on the Lightning concept used a small tank of antifreeze that was hooked up to the truck air conditioning compressor. The air conditioning compressor cooled the antifreeze down to about 30 degrees. The other side of the tank was hooked up to the air-to-water intercooler, which usually had a temperature over 100 degrees. Once the antifreeze was circulated from the tank into the intercooler, it would lower the intercooler temperature and provide for a cooler, denser air charge into the engine; the result was around 50 extra horsepower for a burst of about 30 seconds to a minute, depending on the size of the tank. The system for the Lightning was to be offered as a $750 option and would have been targeted towards drag racers and the like, as it could be used for a run down the drag strip and then re-cooled by the time the truck was back in line. The system was fairly non-intrusive – it only weighed about 25 pounds and did not require a new compressor or intercooler. But as with many concepts, it was ultimately scrapped. The technology was always stuck in the back of my mind, but with larger and more powerful engines being produced it could not find its place. With the advent of new fuel economy standards, we have seen small-displacement turbocharged engines pop up and they seem like the perfect candidate for this type of technology. Ford's EcoBoost 1.0-liter three-cylinder turbocharged engine, as used in the Fiesta and Focus, is one such candidate for this technology. It would add a negligent amount of weight but could provide a boost of 10 to 20 horsepower when needed, like merging onto the highway or catching up to traffic.