Find or Sell Used Cars, Trucks, and SUVs in USA

2000 Ford Ranger Xl Extended Cab Pickup 4-door 3.0l on 2040-cars

US $2,500.00
Year:2000 Mileage:182000
Location:

Delphi, Indiana, United States

Delphi, Indiana, United States
Advertising:

Auto Services in Indiana

Williams Auto Parts Inc ★★★★★

Automobile Parts & Supplies, Used & Rebuilt Auto Parts, Automobile Electrical Equipment
Address: 127 S Detroit Ave, Portland
Phone: (866) 943-9403

Williams Auto Parts Inc ★★★★★

Automobile Parts & Supplies, Used & Rebuilt Auto Parts, Automobile Electrical Equipment
Address: 127 S Detroit Ave, Saratoga
Phone: (866) 943-9403

Webb Hyundai ★★★★★

New Car Dealers, Used Car Dealers
Address: 9236 Indianapolis Blvd, Highland
Phone: (219) 923-2277

Trusty & Sons Tire Co ★★★★★

Auto Repair & Service, Tire Dealers, Brake Repair
Address: 1074 Old Forest Rd NW, Corydon
Phone: (812) 738-4212

Tom Roush Lincoln Mazda ★★★★★

New Car Dealers, Used Car Dealers
Address: 525 David Brown Dr, Westfield
Phone: (866) 869-7884

Tire Barn Warehouse ★★★★★

Auto Repair & Service, Tire Dealers, Wheels-Aligning & Balancing
Address: 9821 Lima Rd, Fort-Wayne
Phone: (260) 490-8473

Auto blog

Check out Ford's fully automated self-parking car [w/video]

Wed, 09 Oct 2013

As automakers continue to find uses for autonomous and semi-autonomous vehicle technology, Ford of Europe has announced that it is developing a self-parking system for future use. More advanced than the Active Park Assist already offered in many Ford products, the new Fully Assisted Parking Aid can take full control of the vehicle and can navigate angled and perpendicular parking spots.
While today's Active Park Assist can only parallel park with the driver controlling the gas, brake and gear selection, Fully Assisted Parking Aid can operate steering, gas, brake and gear selection all while making sure the car is properly parked in the intended space. As with APA, the driver pushes a button to make the car look for a proper spot (at speeds of up to 18 miles per hour), and when an adequate space is located, the operator pushes another button (either inside the car or outside via remote control) for the car to park itself - the button must be pressed throughout the whole parking maneuver. Even though Ford says that the car can effect gear selections on its own, the system must still start from Neutral, and the automaker isn't saying whether the car can put itself into Park when done or put itself in Drive when the operator is ready to go.
Ford is also taking the opportunity to announce its new Obstacle Avoidance technology. This automated system is able to detect objects - including pedestrians - in the road, warn drivers of said objects and, if needed, stop and steer automatically to avoid hitting the obstacle. Both systems are still in the prototype phase, so there is no word as to when we could see either on a production vehicle.

Second-tier UAW workers promoted for first time after Ford hits quota

Mon, Feb 2 2015

The United Auto Workers put out a statement on Friday that 55 Ford workers chosen by seniority would be moved from the Tier 2, entry-level pay rate of around $19 per hour to the Tier 1, non-entry-level rate of about $28 per hour. One of the stipulations in the 2011 UAW-Ford agreement was that only 20-percent of the total hourly workforce could be paid the Tier 2 wages agreed upon in 2007; after that, those workers had to be moved to Tier 1. Even so, the new Tier 1 status makes them less expensive to Ford than veteran Tier 1 workers because they receive fewer benefits. However, Automotive News had reported that same day that Ford was 69 workers shy of the limit, and when AN asked Ford about the situation Ford said it had "some room" on the entry-level roster. If workers do move to the higher pay grade, it will be the first time that's happened since the two-tier system was agreed. But it sounds like there's going to be some haggling between the UAW and Ford before that happens. Ford is the only one of the Detroit 3 automakers to have to work with a cap, since it didn't go through bankruptcy proceedings during The Great Recession; General Motors and Chrysler jettisoned the cap in 2009. GM is said to have 16 percent of its hourly workers at Tier 2 while Chrysler has 42 percent, but Fiat-Chrysler CEO Sergio Marchionne has long been opposed to the two-wage system. The UAW is preparing for its 2015 negotiations with the US automakers. It wants to eliminate the difference in pay by going to the higher scale, if there is a consensus among automakers it seems to be that they also want a single wage, but less than the higher scale, with the addition of profit-based bonuses. The recent statement from the labor union is below. UAW President Dennis Williams and UAW-Ford Vice President Jimmy Settles announced today that the union is delivering on its promise to convert workers DETROIT, Jan. 30, 2015 /PRNewswire/ -- UAW President Dennis Williams and UAW-Ford Vice President Jimmy Settles announced today that the union is delivering on its promise to convert workers making entry-level wages to traditional employees. "The 2011 UAW-Ford agreement allows for a contractual limit of entry-level employees. Once that threshold is surpassed, entry-level employees convert by seniority to 'regular, non-entry level employment.' At this time, fifty-five UAW-Ford workers will receive the wage increases, which put them in the category of non entry-level employment.

Ford cranks up '32 Ford body production

Tue, 14 Jan 2014

If you're going to build your own hot rod, you'll want to start with a '32 Ford 5-Window Coupe. Favored by American servicemen returning from World War II, the '32 Ford remains the very icon of the hot rod to this day. The trouble is there were only so many of them made in the first place, and finding one today can be a challenge. That's where reproduction models come in.
The aftermarket is replete with companies that will sell you a fiberglass body in the form of a '32 Ford coupe, but quality can be hit or miss. So to help meet demand among hot rod builders and enthusiasts, Ford has teamed up with United Pacific Industries to offer officially licensed body shells.
Announced at the SEMA show in November, the '32 Ford 5-Window Coupe body is made from stamped steel according to original specifications from original machinery where possible or reproduced machinery built to the same original specifications where necessary. The bodies are ready to accept vintage powertrains or crate motors from the Ford Racing catalog, and join the 9,000 other parts offered in the Ford Component Sales catalog - including similar reproduction bodies available for the 1965-70 Mustang and 1940 Ford Coupe. From there, the proverbial sky's the limit.