1931 Ford Pickup Roadster Convertible Show Quality! Extremely Rare! V8! Must See on 2040-cars

Auto blog

Ford recalls 90,736 vehicles due to engine valve issue

Ford will recall 90,736 vehicles as engine intake valves in the vehicles may break while driving, the National Highway Traffic Safety Administration (NHTSA) said on Saturday. The recall impacts certain 2021-2022 Bronco, F-150, Edge, Explorer, Lincoln Nautilus, and Lincoln Aviator vehicles equipped with either a 2.7L or 3.0L Nano EcoBoost engine, the NHTSA said. According to documents posted by NHTSA and sourced from the automaker, "The engine intake valves may break while driving, which can result in engine failure and a loss of drive power." Following an investigation that started in January, 2022, Ford found 22 instances where "the engine intake valves fractured and fell into the combustion chamber of the engine causing catastrophic engine damage." The automaker's analysis continues: "Ford identified that the potential root cause of the failures was engine intake valve failure due to valves that exceeded the designed specification for hardness, were brittle, and more likely to fracture. Ford determined that this was due to the supplier’s grinding processes and the sensitivity of the intake valve material to grinding processes that were not within control specifications. The intake valve material was changed for vehicles produced after October 31, 2021." Fixing the problem will require replacement of the entire engine. "Dealers will inspect each vehicle to determine its cumulative number of engine cycles. For vehicles that do not meet the engine cycle threshold, dealers will accumulate high revolutions per minute (rpm) engine cycles per a service procedure. Engines will be replaced on vehicles that do not pass the engine cycle accumulation," Ford says.

Ford unveils all-new 2016 F-650 and F-750 at NTEA

Medium-duty work trucks might not be the most exciting vehicles, but they perform necessary jobs everyday. Ford is in the process of a complete refresh of its entire commercial vehicle lineup over the next 18 months, and it is debuting the all-new versions of its F-650 and F-750 trucks at the NTEA Work Truck Show in Indianapolis, IN.
"The all-new F-650/F-750 allow us to leverage our strengths and sales leadership in Classes 1 to 5 to create a better F-650/F-750 that's designed, engineered and built by Ford in the USA," said Ford spokesperson Mike Levine to Autoblog via email.
Huge amounts of torque is vital for trucks like these, and both models are offered with some of Fords biggest engines. Buyers can opt for either the 6.7-liter Power Stroke V8 diesel with TorqShift 6-speed automatic with available power takeoff or a gasoline-fueled 6.8-liter V10 with a 6-speed automatic. The V10 can also be ordered from the factory to be fueled by compressed natural gas or liquid propane gas.

Shelby GT500 and Roush Stage 3 go head to head at the drag strip

The Ford Mustang is a brilliantly affordable source of horsepower, with a base 300-plus-horsepower version available for well under $30,000. Jumping up to about $35,000 will get you a solid 420 horsepower from a high-revving V8, while those with some extra disposable income can get a pair of 600-plus-horsepower monsters. Both the Roush Stage 3 with its Phase 3 package and Ford's factory Shelby GT500 even crest the 650-horsepower mark, with 675 and 662 ponies, respectively.
Naturally, someone needed to find out which of these hi-po Mustangs was the quickest. And while this video is quite obviously a dealership commercial, at least there's some solid drag racing between two of the most powerful performance machines available for under $100,000.
With two NHRA drag racers at the wheel, the Stage 3 and GT500 go head to head for three races. Scroll down below to see the results in the full video.