89' Convertible Black Ford Mustang Gt 5.0 on 2040-cars

Auto blog

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

For thousands of US auto workers, the downturn is already here

LORDSTOWN, Ohio - Wall Street is fretting that the auto industry is heading for a downturn, but for thousands of workers at General Motors factories in the United States, the hard times are already here. Matt Streb, 36, was one of 1,200 workers laid off on Jan. 20 - inauguration day for President Donald Trump - when GM canceled the third shift at its Lordstown small-car factory here. Sales of the Chevrolet Cruze sedan, the only vehicle the plant makes, have nosedived as consumers switch to SUVs and pickup trucks. Streb is looking for another job, but employers are wary because they assume he will quit whenever GM calls him back. "I get it," said Streb, who has a degree in communications, "but it's frustrating." Layoffs at Lordstown and other auto plants point to a broader challenge for the economy in Midwestern manufacturing states and for the Trump administration. "This is about economics, not what Trump says. Even if Trump went out and bought 10,000 Cruzes a month, he wouldn't get the third shift back here." The auto industry's boom from 2010 through last year was a major driver for manufacturing job creation. The fading of that boom threatens prospects for US industrial output and job creation that were central to Trump's victory in Ohio and other manufacturing states. "This is about economics, not what Trump says," said Robert Morales, president of United Auto Workers (UAW) union Local 1714, which represents workers at GM's stamping plant at Lordstown. "Even if Trump went out and bought 10,000 Cruzes a month, he wouldn't get the third shift back here." Last week the Federal Reserve said factory output fell 0.4 percent in May, the second decline in three months, due partly to a 2 percent drop in motor vehicles and parts production. Mark Muro, a senior fellow at the Brookings Institution, has compiled data from government sources that show the auto industry punching higher than its weight in job creation in recent years - accounting for between 60 percent and 80 percent of all US manufacturing jobs added in 2015 and 2016. In the first quarter of this year, the auto industry accounted for less than 2 percent of the 45,000 manufacturing jobs created. "There's no argument with the idea that auto has been pulling the manufacturing sled up the mountain for the last three or four years," Muro said.

Check out Ford's fully automated self-parking car [w/video]

As automakers continue to find uses for autonomous and semi-autonomous vehicle technology, Ford of Europe has announced that it is developing a self-parking system for future use. More advanced than the Active Park Assist already offered in many Ford products, the new Fully Assisted Parking Aid can take full control of the vehicle and can navigate angled and perpendicular parking spots.
While today's Active Park Assist can only parallel park with the driver controlling the gas, brake and gear selection, Fully Assisted Parking Aid can operate steering, gas, brake and gear selection all while making sure the car is properly parked in the intended space. As with APA, the driver pushes a button to make the car look for a proper spot (at speeds of up to 18 miles per hour), and when an adequate space is located, the operator pushes another button (either inside the car or outside via remote control) for the car to park itself - the button must be pressed throughout the whole parking maneuver. Even though Ford says that the car can effect gear selections on its own, the system must still start from Neutral, and the automaker isn't saying whether the car can put itself into Park when done or put itself in Drive when the operator is ready to go.
Ford is also taking the opportunity to announce its new Obstacle Avoidance technology. This automated system is able to detect objects - including pedestrians - in the road, warn drivers of said objects and, if needed, stop and steer automatically to avoid hitting the obstacle. Both systems are still in the prototype phase, so there is no word as to when we could see either on a production vehicle.