1927 Ford Roadster on 2040-cars

Auto blog

An amazing Group B rally car collection heads to auction

Kicking off in 1982, the Group B era spawned some of the most fearsome rally cars of all time. The technologically advanced pioneers of all-wheel drive and turbocharging defined a time when automakers had carte blanche to build machines with unrestricted power, without the burden of homologating a large number of road cars to qualify. The results were sometimes deadly, leading the FIA to ban the class after 1986. Now, a collection of seven Group B monsters is headed across the block in Paris as part of the Artcurial auction, held in partnership with France's famed Retromobile show. The show has been delayed to June, however. There's a 1985 Peugeot 205 Turbo 16, one of 20 Evo II models that helped the company achieve two championships in Group B's short run. This particular example was driven by world champion Timo Salonen at the 1986 Swedish Rally, where it finished seventh due to an oil filter seal failure. Bruno Saby subsequently drove it at the 1986 Tour de Corse and Peugeot entered it at the 1986 Acropolis Rally as well. It's still registered to Peugeot Talbot Sport and represents a French technological achievement, according to Artcurial, comparable to the Concorde or TGV train. Representing Italy are a pair of Lancias in the iconic Martini livery. The Lancia 037 helped Bel Paese clinch its only Group B victory in 1983, after a hard-fought rivalry with Audi. It's one of the few Group B cars that weren't AWD, achieving its success the old-fashioned way, through lightness and superb handling. A second Lancia, a 1986 Delta S4, was the culmination of the Italian firm's later Group B efforts and one of Saby's favorites. While Group B was no more in 1987, the S4 was the predecessor to the Delta Integrale that would dominate WRC from 1987 through 1992. While the collection also includes greats like a Ford RS200, Renault 5 Maxi Turbo, and MG Metro 6R4, the centerpiece is the Audi Quattro Sport S1. The ultimate Group B machine, it introduced all-wheel-drive and turbocharging to the sport. It also employed the wildest use of wings and air dams to generate downforce. Tunable up to 590 horsepower, it could rocket to 60 mph in about three seconds. The car offered for sale came straight from Ingolstadt, a 1988 model built for the Race of Champions of ex-Group B cars. The collection was amassed in the late 80s and early 90s, not long after Group B's dissolution.

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.

Ford recalling 12,300 2015 F-150 pickups

Ford is recalling 12,300 of its new 2015 F-150 pickup trucks in North America. According to the automaker, an upper l-shaft may have been riveted improperly on these trucks, which can cause it to separate. If that happens, drivers may lose steering control without warning. Yikes. The affected trucks were built at Ford's Kansas City Assembly Plant between March 21 and 25, as well as the Dearborn Truck Plant between March 21 and 30. There are 12,328 total trucks included in this recall – 8,963 in the United States, 3,348 in Canada, and 17 in Mexico. Only 5,606 of the trucks are in customers' hands, the rest have yet to be sold. Ford is not aware of any accidents or injuries related to this problem, but knows of one incident where steering control was lost, and believes it to be related to this issue. Scroll down for Ford's official statement. Related Video: FORD ISSUES SAFETY RECALL FOR CERTAIN 2015 FORD F-150 VEHICLES IN NORTH AMERICA FOR UPPER I-SHAFT RIVET ISSUE Ford Motor Company is issuing a safety recall for approximately 12,300 2015-model Ford F-150 vehicles in North America for an upper I-shaft that might have been riveted improperly, potentially causing it to separate. If that happens, it could result in the loss of steering control without warning, increasing the risk of a crash. Ford is not aware of any accidents or injuries, but is aware of one report of loss of steering believed to be related to this condition. Affected vehicles include certain 2015 F-150 vehicles built at Kansas City Assembly Plant from March 19, 2015 to March 21, 2015 and certain 2015 F-150 vehicles built at Dearborn Truck Plant from March 21, 2015 to March 30, 2015. There are 12,328 vehicles that might be affected in North America, including 8,963 in the United States and federalized territories, 3,348 in Canada and 17 in Mexico. Of those, 6,722 vehicles are unsold, meaning 5,606 vehicles are in customer's hands. Dealers will inspect the upper I-shaft assembly and replace it if necessary at no cost to the customer.