Hot Rod Rat Rod Street Rod Custom Show Car Rumble Seat Project on 2040-cars

Auto blog

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.

2015 F-150 launch to curb Ford profits?

Ford is making a big bet on aluminum with its new 2015 F-150, and it's possible that the decision will hurt the company financially, at least in the short term. After earning a record $8.6 billion in 2013, the Blue Oval does not expect to set another record in 2014. According to Automotive News, that's "largely attributable to F Series," says Bob Shanks, Ford's Chief Financial Officer.
To retool for the new F-150, Ford will idle its Dearborn Truck Plant in Michigan for 11 weeks and the Ford Kansas City Assembly Plant in Missouri for 2 weeks. "3 of the 13 overall weeks occur during what normally is our summer shutdown timeframe," said Mike Levine, Ford Trucks Communication Manager, in an email to Autoblog. The extra 10 weeks will be preparing for the more aluminum-intensive construction for the trucks and will mean over 2 months of no F-150s being made. For comparison's sake, Chrysler boss Sergio Marchionne just confirmed that the 200 plant in Sterling Heights, MI will be down for 30 days to retool for the new model, but obviously there are many more F-150 production variables than for the midsize sedan.
Levine notes that Ford is already running three shifts at both plants, and says the automaker has plans to ensure that there is adequate supply of the full-size pickups during the retooling process. The company does not want to suffer a shortage of the vehicle that accounted for 31-percent of its 2013 US sales and an even bigger percentage of its profits.

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.