1929 Ford Roadster Hotrod "old Skool Kool" on 2040-cars

Auto blog

Ford recalls 83k Taurus and crossover models for halfshaft issue

Ford and the National Highway Traffic Safety Administration have issued a recall for some 83,250 vehicles in the US, for an issue with halfshafts. More specifically a "halfshaft retention circlip" might not have been properly installed on affected vehicles, with the result being halfshafts that may move improperly or disengage completely from the linkshaft while driving. The NHTSA release also notes that the issue may occur "without prior warning" which obviously factors in to the timeliness of getting this checked.
Should the halfshaft disengage, a few troubling things could happen. If it occurs while driving, power from the engine will no longer be transmitted to the wheels. And, if the vehicle is parked without the parking brake applied after disengagement of the circlip, vehicles may roll away even if they're transmissions have been placed in "Park."
Affected vehicles are as follows: Ford Edge and Lincoln MKX crossovers from model years 2012 to 2014; Ford Taurus and Lincoln MKS sedans from model years 2013 to 2014; Ford Flex and Lincoln MKT vehicles from model years 2013 to 2014.

U.S. automakers unite in opposition to possible Trump vehicle tariffs

WASHINGTON — The U.S. auto industry urged President Donald Trump's administration on Monday not to saddle imported cars and auto parts with steep tariffs, after the U.S. Commerce Department sent a confidential report to the White House late on Sunday with its recommendations for how to proceed. Some trade organizations also blasted the Commerce Department for keeping the details of its "Section 232" national security report shrouded in secrecy, which will make it much harder for the industry to react during the next 90 days Trump will have to review it. "Secrecy around the report only increases the uncertainty and concern across the industry created by the threat of tariffs," the Motor and Equipment Manufacturers Association said in a statement, adding that it was "alarmed and dismayed." "It is critical that our industry have the opportunity to review the recommendations and advise the White House on how proposed tariffs, if they are recommended, will put jobs at risk, impact consumers, and trigger a reduction in U.S. investments that could set us back decades." Representatives from the White House and the Commerce Department could not immediately be reached. The industry has warned that possible tariffs of up to 25 percent on millions of imported cars and parts would add thousands of dollars to vehicle costs and potentially devastate the U.S economy by slashing jobs. Administration officials have said tariff threats on autos are a way to win concessions from Japan and the EU. Last year, Trump agreed not to impose tariffs as long as talks with the two trading partners were proceeding in a productive manner. "We believe the imposition of higher import tariffs on automotive products under Section 232 and the likely retaliatory tariffs against U.S. auto exports would undermine - and not help - the economic and employment contributions that FCA, US, Ford Motor Company and General Motors make to the U.S. economy," said former Missouri Governor Matt Blunt, the president of the American Automotive Policy Council. Some Republican lawmakers have also said they share the industry's concerns. In a statement issued on Monday, Republican Congresswoman Jackie Walorski said she fears the Commerce Department's report could "set the stage for costly tariffs on cars and auto parts." "President Trump is right to seek a level playing field for American businesses and workers, but the best way to do that is with a scalpel, not an axe," she added.

2017 Ford F-150 Raptor desert testing heats up

In case there was any doubt, Ford is taking the development of the second-generation SVT Raptor very, very seriously. The Blue Oval recently completed over 1,000 miles of testing in the boiling heat of the American southwest. Apparently, that mileage was accrued over a 66-mile route designed to mimic the torturous terrain encountered by racers in the Baja 1,000 off-road race. The prototypes, which were built from a mix of existing and next-gen Raptor components, were tested with "fast sandy washes, deep-rutted silt beds, steep climbs in deep sand, and slow meticulous crawls through tight trenches." Ford claims the new truck managed to run the circuit 25-percent faster than the current F-150 SVT Raptor, averaging 50 miles per hour while going as fast as 100 mph in stretches. That said, Dearborn didn't release any dedicated times, so it's unclear just how quickly the 66-mile stage was completed. We do know that durability was a big part of the testing. Ford claims each lap was completed by what sounds like a pretty significant jump, with the trucks ascending a steep ramp onto a two-foot plateau and then completing a step-down to level ground. We have to take Ford at its word here, though. "Steep" can mean any number of things, and we've no idea just how fast the trucks were hitting the ramp or how much air they got. Hopefully, the jumps were aggressive enough to prevent future frame issues. Still, Ford boasting about how rough the Raptor's testing is can be taken as a positive sign for fans of the next-generation of SVT's rugged pickup. NEW F-150 RAPTOR WRAPS UP INITIAL DESERT DURABILITY TESTING DEARBORN, Mich., July 7, 2015 – The 2017 F-150 Raptor – Ford's toughest, smartest, most capable off-road truck ever – recently completed more than 1,000 miles of testing in the southwestern United States. Over 1,028 miles of desert trail designed to parallel the Baja race course in Mexico, the 66-mile route featured a wide range of surfaces including fast sandy washes, deep-rutted silt beds, steep climbs in deep sand, and slow meticulous crawls through tight trenches. The truck topped speeds of 100 mph in places, slowing to 10 mph in others, for an average speed of approximately 50 mph. The 2017 Raptor is 25 percent faster than the current truck based on lap times. At the end of each lap, the new Raptor completed a tabletop jump consisting of a steep ramp up to a two-foot plateau, then a step-off back to level ground.