1928 Ford Model A 1 Ton Very Rare Hilo Trans All Original Collector Truck on 2040-cars

Auto blog

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

NHTSA opens investigation into Ford Explorer PI brakes

This year more than most, it's pleasant when we can string together a few days without word of an automaker or the National Highway Traffic Safety Administration announcing a bunch of new recalls. It's seemingly been a little quiet on this front lately (barring a spider-related Suzuki issue revealed early today), but now we have word of the government safety agency opening a Preliminary Evaluation into the 2013 Ford Explorer Police Interceptor, a probe that could potentially affect an estimated 20,000 vehicles.
The issue being investigated concerns failures of the front brake hose on the vehicle that show "small splits in the hoses near the body side ferrule of the hose assembly," according to the agency, and the issue could result in longer stopping distances. The feds have reports of 13 malfunctions affecting 11 Explorer units. However, it's important to note that all of the incidents come from a single, unnamed metropolitan police fleet that operates 46 of them. According to The Detroit News, the failures generally took place between December and July.
NHTSA is investigating further to find if this is a more widespread issue than just this one fleet. Ford spokesperson Kelli Felker confirmed to us, "We are cooperating with NHTSA on this investigation, as we always do." Scroll down to read the agency's report.

Ford adding second supplier for F-150 frames

Metalsa, the company that builds steel frames for the aluminum-bodied Ford F-150, is still having trouble providing enough frames to supply the two factories that build the pickup. The snafu is preventing Ford from selling as many of the country's best-selling truck as it could, and eating into profits - even though the bottom line is still breaking company records. According to The Wall Street Journal, Ford has picked Michigan company Tower International as a second frame supplier and expects to have inventory up to a proper level at the beginning of Q4 of this year. Neither Ford nor Tower would confirm the development - Automotive News got comments from a source and pieced together bits of info from Tower's financial statements and local press reports. Tower currently builds body structures for several vehicles, including the F-series, and the Bellevue, Ohio factory that will build F-150 frames previously manufactured frames for the Ranger and Econoline. According to a story in the local Sandusky Register, Tower will add one production line at the end of next month to begin shipping frames in October, and another line in April 2016. Something like 138 full-time workers and 364 robots are expected to carry out the work. Tower's most recent financial statement said that capital investment will be necessary to get everything set up, but the contract will be worth $140 million in yearly revenue.