1959 Ford Custom 300 Tudor Sedan 2 Door Nice- California Car on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

Ford to auction Mustang Cobra Jet prototype for charity [w/video]

Prototypes developed by major automakers typically remain in said company's custody, but every once in a while, one trickles out into private hands. And that's just what we have here. Ford is donating a one-of-a-kind factory prototype for the 2014 Mustang Cobra Jet that will be auctioned off later this month by Barrett-Jackson in Las Vegas to benefit the National Multiple Sclerosis Society.
Powered by a 5.0-liter supercharged V8 mated to a T4 competition gearbox, this rare Cobra Jet prototype includes a wheelie bar, chromoly roll cage, Weld wheels, three-link rear suspension, racing brakes, 9-inch rear axle and more. It's painted in a unique satin orange with reflective gray striping scheme, bears the serial number 2014 BJMS CJXX1 and is fully ready for NHRA competition on the drag strip.
To be offered with no reserve on Saturday, September 28, 2013, the Cobra Jet prototype's winning bidder will also receive tutelage at Roy Hill's Drag Racing School in Sophia, NC, along with tours of the Ford Product Development Center, Ford Racing headquarters and Ford Design Studios with Mustang chief engineer Dave Pericak. Scope out the video and details below for what could be the ultimate Mustang experience for a good cause.

Toyota fears supplier pressure in Australia with GM pull out

With Ford and General Motors both announcing an end to production in Australia, the country's auto industry is in a bad way. With the exit of two big players, there's increased concern that a third Australian manufacturer, Toyota, will be forced out, as well.
"We are saddened to learn of GM Holden's decision. This will place unprecedented pressure on the local supplier network and our ability to build cars in Australia," Toyota Australia said in a statement. The GM closure of Holden production will be the direct end to 2,900 jobs, but will also force a dramatic reduction in the size of the country's supplier network, as there will simply be fewer cars to build.
In the same statement, Toyota Australia said it would work with suppliers and local government to figure out whether continuing production Down Under was even feasible. According to Automotive News, a representative for the Australian Manufacturing Workers' Union told reporters it was "highly likely" that Toyota would also close up shop within the next few years.