Xlt Powerstroke Diesel New Tires Clean History Excellent Condition on 2040-cars

Auto blog

2017 Ford F-150 Raptor desert testing heats up

In case there was any doubt, Ford is taking the development of the second-generation SVT Raptor very, very seriously. The Blue Oval recently completed over 1,000 miles of testing in the boiling heat of the American southwest. Apparently, that mileage was accrued over a 66-mile route designed to mimic the torturous terrain encountered by racers in the Baja 1,000 off-road race. The prototypes, which were built from a mix of existing and next-gen Raptor components, were tested with "fast sandy washes, deep-rutted silt beds, steep climbs in deep sand, and slow meticulous crawls through tight trenches." Ford claims the new truck managed to run the circuit 25-percent faster than the current F-150 SVT Raptor, averaging 50 miles per hour while going as fast as 100 mph in stretches. That said, Dearborn didn't release any dedicated times, so it's unclear just how quickly the 66-mile stage was completed. We do know that durability was a big part of the testing. Ford claims each lap was completed by what sounds like a pretty significant jump, with the trucks ascending a steep ramp onto a two-foot plateau and then completing a step-down to level ground. We have to take Ford at its word here, though. "Steep" can mean any number of things, and we've no idea just how fast the trucks were hitting the ramp or how much air they got. Hopefully, the jumps were aggressive enough to prevent future frame issues. Still, Ford boasting about how rough the Raptor's testing is can be taken as a positive sign for fans of the next-generation of SVT's rugged pickup. NEW F-150 RAPTOR WRAPS UP INITIAL DESERT DURABILITY TESTING DEARBORN, Mich., July 7, 2015 – The 2017 F-150 Raptor – Ford's toughest, smartest, most capable off-road truck ever – recently completed more than 1,000 miles of testing in the southwestern United States. Over 1,028 miles of desert trail designed to parallel the Baja race course in Mexico, the 66-mile route featured a wide range of surfaces including fast sandy washes, deep-rutted silt beds, steep climbs in deep sand, and slow meticulous crawls through tight trenches. The truck topped speeds of 100 mph in places, slowing to 10 mph in others, for an average speed of approximately 50 mph. The 2017 Raptor is 25 percent faster than the current truck based on lap times. At the end of each lap, the new Raptor completed a tabletop jump consisting of a steep ramp up to a two-foot plateau, then a step-off back to level ground.

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

Ford unveils its facelifted Falcon finale with new XR8

While its days may be numbered, Ford isn't just going to let its Falcon sedan limp out for the Australian market. No, the Blue Oval is releasing a refreshed Falcon for its final years, and it's lead by this, the new XR8. That's right, this dead-car-driving is going to go out on a high note.
Ford's global design DNA dominates the looks of the new Falcon, with a grille reminiscent of the US market Fusion and the European-market Mondeo. The headlights aren't a straight port, and boast their own unique LED running light pattern (at least on the XR8), but the overall look is strikingly similar. Out back, LED taillights highlight the rear of the Faclon. Despite the substantial new fascia, this is still a mid-cycle refresh. That means most of the rest of the Falcon's body panels are carryovers from the current model.
The XR8 model, shown above, arrives with a supercharged V8, allegedly displacing 5.0 liters. Unfortunately, details on the Falcon's mechanicals are in remarkably short supply. Ford has committed to a range of turbocharged four, as well as turbocharged and naturally aspirated six-cylinders, in addition to the V8, although specifics on those mills aren't available.