Lariat Crew Cab 4x4 Navigation Fisher Snow Plow Powerstroke Diesel No Reserve on 2040-cars

Auto blog

2021 Ford F-150 Raptor vs. 2021 Ram 1500 TRX | How they compare on paper

Yep, the F-150 Raptor is back, though you'd be forgiven for not noticing that it ever left. Ford's off-road model is taking a few months off to accommodate the broader 2021 F-150 redesign from which it benefits. And the fine folks over at Ram took full advantage of that lull to launch the new 702-horsepower TRX, which in one big way (hint: it's the engine) stands at the top of the performance pickup heap. Ford says that's all going to change in 2022, but for now, the Raptor returns with a familiar 3.5-liter EcoBoost V6 (albeit with an unspecified power figure) along with several other revisions to Ford's tried-and-true formula. The 2020 Raptor was already a worthy adversary to the beefy Ram despite the latter's definitive power advantage, so how has that picture evolved for 2021? Let's take a look.    Powertrain This is a big question mark for the Ford right now, but it seems reasonable to expect a bit more than the outgoing model's 450 horsepower and 510 pound-feet of torque. The TRX's Hellcat-sourced powerplant needs no introduction. Its 702 horsepower will easily eclipse whatever Ford has planned for its 3.5-liter twin-turbo V6, even if the V6 has more grunt than it did before, but that's OK. It's not the base-model Raptor's job to dethrone the TRX in straight-line speed; that honor will go to the 2022 Raptor R. We also don't know what the Raptor's fuel economy will be like, but we suspect it will be better than the TRX's, if only slightly.  Both these trucks come with four-wheel-drive standard, and they both have a number of drive modes that alter the powertrain’s characteristics depending on the terrain. Baja mode transforms the trucks into the desert runners that they both are at heart, but theyÂ’re plenty capable of crawling around rocks, too. We wonÂ’t know for certain which is best at specific tasks until we can get them both on (or off) equal ground. Suspension / off-roading capability And the ground is where things narrow significantly, both on- and off-paper. The specs are freakishly similar when we compare ground clearance, approach/departure angles and water fording, but the Raptor's leapfrog here is clearly evident. Both trucks utilize a coil-sprung rear suspension now, with Ford having abandoned the Raptor's previous leaf-spring setup with the redesign.  The two use different shocks to handle 100-mph-plus desert running.

NHTSA closes rollaway investigation into 1.56M Ford SUVs

It's taken four years of study, but the National Highway Traffic Safety Administration has finally closed the books on its investigation into rollaway accusations surrounding 1.56-million Ford SUV models.
The probe, which centered on the 2002-2005 Ford Explorer, 2002-2005 Mercury Mountaineer and 2003-2005 Lincoln Aviator, ends without the federal agency calling for a recall. According to The Detroit News, the investigation was closed due to a "low number of complaints" - NHTSA documented 180 such complaints that resulted in 14 crashes and six minor injuries, but the number of incidents have been slowing. The suspected defect rate for the trucks' automatic transmissions was found to be 4.4 per 100,000 units, and the brake-shift interlock mechanism failure rate was judged to be even lower at 3.4 per 100k.

Watch as U.S. auto industry springs back to life after lockdown

WARREN, Michigan — The Detroit Three automakers and their suppliers began restarting assembly lines on Monday after a two-month coronavirus lockdown in a slow revival of a sector that employs nearly 1 million people in the United States. On a chilly and damp Monday morning, hundreds of workers at Fiat Chrysler Automobile's (FCA) truck plant in Warren, Michigan, began lining up before 4 a.m. to start the 5 a.m. shift. Signs overhead read: "Let's restart." "I'm a little nervous," said Larry Smith, 53, of New Baltimore, who works on wheel alignment away from the assembly line. "They made all the precautions (and) they've done everything they can to prepare us ... I'm trusting in God." Detroit automakers on Monday said there were no issues with absenteeism as the plants opened. FCA reopened four U.S. assembly plants on Monday, including Warren Truck, on a single shift, as well as four parts plants. The reopening of car plants will be a closely watched test of whether workers across a range of U.S. industries can return to factories in large numbers without a resurgence of infections. General Motors Co, Ford Motor Co and FCA have all been preparing for weeks to reopen their North American factories in a push to restart work in an industry that accounts for about 6% of U.S. economic activity. Investors welcomed the gradual restart, sending GM's shares up more than 9% on Monday. FCA shares rose 7.3%, while Ford's were up 6.7%. Auto companies have redesigned assembly lines and retrained workers in an effort to avoid coronavirus outbreaks that could derail production again. Workers entering factories on Monday were checked by temperature monitors. Face masks or shields are standard protective equipment. Jobs such as installing seat belts that used to require two or more workers to get close together inside a vehicle have been redesigned to keep people a safe distance apart. Plastic screens have been installed along assembly lines to separate workers leaning in to the engine compartments of vehicles. Break areas have been reconfigured to keep workers six feet apart. The Detroit automakers have collaborated with each other and with the United Auto Workers to develop common coronavirus safety practices. Other automakers in the United States are adopting similar safety measures.