2009 Ford F-250 Super Duty Xl on 2040-cars

Auto blog

Ford Fiesta ST orders off to strong start

We at Autoblog love the new little Ford Fiesta ST, and apparently, folks in Europe are pretty impressed with it, as well. According to Ford, the automaker's European arm has already logged 3,000 orders for the new hot hatch since it hit dealerships this March. The US-spec car, which will only be available as a five-door, will go on sale in the United States this summer.
What's perhaps most interesting about the Fiesta ST ordering is that the majority of customers appear to be ordering high-spec cars. According to Ford data, 60 percent of customers have opted for the leather interior with Recaro buckets, and 90 percent have selected the upgraded 17-inch wheels (seen on our test car, above). Spirit Blue has been the most popular color, commanding 27 percent of all orders. As for the technology upgrades, 19 percent of customers have ponied up for the Sony stereo with navigation.
To recap, the Fiesta ST is offered with Ford's 1.6-liter EcoBoost four-cylinder engine, putting out 179 horsepower and 177 pound-feet of torque, mated exclusively to a six-speed manual transmission. We had an absolute blast flinging the hot Fiesta through the French Alps, and we can't wait for this sharp little hatch to make its way over to the States.

Ford recalls 90,736 vehicles due to engine valve issue

Ford will recall 90,736 vehicles as engine intake valves in the vehicles may break while driving, the National Highway Traffic Safety Administration (NHTSA) said on Saturday. The recall impacts certain 2021-2022 Bronco, F-150, Edge, Explorer, Lincoln Nautilus, and Lincoln Aviator vehicles equipped with either a 2.7L or 3.0L Nano EcoBoost engine, the NHTSA said. According to documents posted by NHTSA and sourced from the automaker, "The engine intake valves may break while driving, which can result in engine failure and a loss of drive power." Following an investigation that started in January, 2022, Ford found 22 instances where "the engine intake valves fractured and fell into the combustion chamber of the engine causing catastrophic engine damage." The automaker's analysis continues: "Ford identified that the potential root cause of the failures was engine intake valve failure due to valves that exceeded the designed specification for hardness, were brittle, and more likely to fracture. Ford determined that this was due to the supplier’s grinding processes and the sensitivity of the intake valve material to grinding processes that were not within control specifications. The intake valve material was changed for vehicles produced after October 31, 2021." Fixing the problem will require replacement of the entire engine. "Dealers will inspect each vehicle to determine its cumulative number of engine cycles. For vehicles that do not meet the engine cycle threshold, dealers will accumulate high revolutions per minute (rpm) engine cycles per a service procedure. Engines will be replaced on vehicles that do not pass the engine cycle accumulation," Ford says.

Ford using robot drivers to test durability [w/video]

In testing the durability of its upcoming fullsize Transit vans, Ford has begun using autonomous robotic technology to pilot vehicles through the punishing courses of its Michigan Proving Grounds test facility. The autonomous tech allows Ford to run more durability tests in a single day than it could with human drivers, as well as create even more challenging tests that wouldn't be safe to run with a human behind the wheel.
The technology being used was developed by Utah-based Autonomous Solutions, and isn't quite like the totally autonomous vehicles being developed by companies like Google and Audi for use out in the real world. Rather, Ford's autonomous test vehicles follow a pre-programmed course and their position is tracked via GPS and cameras that are being monitored from a central control room. Though the route is predetermined, the robotic control module operates the steering, acceleration and braking to keep the vehicle on course as it drives over broken concrete, cobblestones, metal grates, rough gravel, mud pits and oversize speed bumps.
Scroll down to watch the robotic drivers in action, though be warned that you're headed for disappointment if you expect to see a Centurion behind the wheel (nerd alert!). The setup looks more like a Mythbusters experiment than a scene from Battlestar Galactica.