2006 Ford F250 Lariat Loaded!! on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

2015 Saleen 302 Black Label Mustang unveiled with 730 horsepower

The last time Saleen made these pages it was to report that the firm was out of money. However, just before that announcement, the tuning specialist told us about the three Saleen 302 Mustangs it was developing at three levels - White Label, Yellow Label and Black Label, with those latter two trims to put out 640 horsepower and 565 pound-feet of torque. Well, the Black Label is here - don't let the California Sunset paint fool you - and it's more powerful than planned, with 730 hp and 600 lb-ft blasted out of a 5.0-liter Coyote V8 hooked up to a twin-screw supercharger. Saleen says it's the most powerful, refined, and advanced Mustang it has ever built. Keeping all that power on the road is the increase in downforce that comes from a body that's been extended one inch in front and two inches in the back, and the wing suspended over the decklid. The stock suspension is refitted with Saleen S4 springs, shocks, swaybars and bushings, and the 20-inch wheels on 275-section rubber hide 15-inch dimpled rotors. The interior gets the requisite frills in leather and contrasting stitches, as well as new gauges and badging. It'll take $73,214 to open the door, but just $2,015 to put down a deposit. For more info, check out the press release below. Related Video: 2015 Saleen 302 Black Label Mustang March 15, 2015 -- Earlier this year, Saleen Automotive released their 2015 White and Yellow Label 302 Mustangs to much fanfare. To round out their fleet, Saleen pulled out all the stops and developed one of the best Mustangs to date. This car is set to change the way pony cars are looked at from here on out. At a one-of-a-kind event in Downtown LA, Saleen raised the curtain on the latest pony car out of their Corona, CA headquarters. "Since I started building cars in 1984 my goal has always been to go above and beyond where anybody has been before", said Steve Saleen. "This will by far be the most refined and advanced Mustang we have built to date." With over 30 years of experience in both racing and manufacturing vehicles, it was only a matter of time before Saleen built a Mustang as comprehensive and technologically advanced as the 2015 302 Black Label. Power Saleen combined the reliability and potency of the 5.0L Coyote motor with a twin-screw supercharger. The pair produces the most power from a production Mustang yet at 730 horsepower and 600 lb-ft of torque on 91 octane gas.

Autoblog Minute: Trump blasts Ford in visit to Michigan

Donald Trump takes a shot at Ford's outsourcing practices in his most recent visit to Michigan. Autoblog's Mylencia Gillenwaters reports on this edition of Autoblog Minute. Show full video transcript text [00:00:00] Donald Trump takes a shot at Ford's outsourcing practices in his most recent visit to Michigan. I'm Mylencia Gillenwaters and this is your Autoblog Minute. Presidential hopeful Donald Trump visited Birch Run, Michigan for a rally, and amidst talk of immigration and international trade, the GOP front runner discussed Ford's plan to build a manufacturing plant in Mexico: [00:00:30] [WXYZ NEWS CLIP] Autoblog reached out to Ford for comment. The Dearborn-based automaker offered this statement in response: "We are committed to leveraging our global manufacturing footprint and will continue to invest where it makes the best sense for our business. We are proud that we have invested $6.2 billion in our U.S. plants since 2011 and hired nearly 25,000 U.S. employees. [00:01:00] Overall, 80 percent of our North American investment annually is in the U.S., and 97 percent of our North American engineering is conducted in the U.S." As automakers compete in an increasingly global marketplace, debate around outsourcing is sure to remain a hot political topic. For Autoblog, I'm Mylencia Gillenwaters. Autoblog Minute is a short-form video news series reporting on all things automotive. Each segment offers a quick and clear picture of what's happening in the automotive industry from the perspective of Autoblog's expert editorial staff, auto executives, and industry professionals.