1966 Ford F250 Camper Special, Custom Cab on 2040-cars

Auto blog

2017-19 Ford Super Duty trucks recalled for tailgates that could open

Ford announced two separate recalls today, though neither has resulted in any known injuries. The first recall, which deals with a tailgate malfunction, affects 261,617 examples of 2017-2019 F-250, F-350, and F-450 Super Duty pickups. The second, which anticipates the possibility of a fuel leak, affects 3,893 units of 2020 Explorer and 2020 Lincoln Aviator SUVs with 3.0-liter engines. Ford says tailgates might accidentally open on some 2017-2019 Super Duty trucks because of a short circuit. If the pickups have an electric tailgate latch-release switch on the tailgate handle, water might get into the wiring. If the water hits the right spots, a short circuit could cause the switch to release the tailgate latch. In a worst-case scenario where the tailgate opens while driving, contents of the truck's bed could fall out and create a safety hazard. Dealerships will fix the problem by modifying the tailgate frame wiring harnesses with jumper pigtails and install a new tailgate handle release switch. Of the lot, 231,664 trucks are in the U.S., and 29,953 are in Canada. The Ford recall number is 19S48.  The second recall is much smaller, involving fewer than 4,000 vehicles. In certain 2020 Explorers and Aviators with 3.0-liter engines, Ford says, "The convolute protective sleeve on the liquid fuel line is not long enough, which may allow for potential hard contact with the convolute-protected vapor fuel line. Over time, with vibration and engine roll, hard contact between the two fuel lines could cause the convolute on the vapor fuel line to rub through the plastic liquid fuel line." If that happens, it could be a fire risk and hazardous for drivers and passengers. Only 35 of those SUVs are in Canada, and the rest are in the United States. Dealers will fix the problem by replacing the defective convolute with a full-length piece and tying it down with a strap. The recall reference number for the Aviators and Explorers is 19S49. The recall adds to what has otherwise been a rocky early production phase for the new Explorers and Aviators.

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).

Mysterious small Ford spied in Germany

Our spy photographers have just popped off a few shots of something curious. This little runabout was spotted in Germany out testing with a current-generation Ford Fiesta. We're fairly confident the machine is a Ford, but exactly which Ford model is up for debate. The hatchback could be the next-generation Ka, but we've also heard that the Blue Oval supermini might not get a replacement. Our shooter says the five-door is a bit smaller than the current Fiesta, though there is a chance that this rig is just an engineering mule for drivetrain development. Then again, it could be a model built specifically for the South African market or China, or not a Ford at all.
Whatever it is and wherever it's headed, you can check out in the gallery for a closer look before heading into Comments to weigh in with your best guess.