2011 Ford F150 4x2 Platinum 3.5l Nav Cd Moonroof Power Running Boards on 2040-cars

Auto blog

Ford Mustang Mach-E fails Sweden's moose test

The infamous moose test has claimed another casualty. This time it's the Ford Mustang Mach-E AWD Long Range, which was tested in an electric four-way alongside the Tesla Model Y, Hyundai Ioniq 5 and Skoda Enyaq iV (an electric utility vehicle closely related to the Volkswagen ID.4 that is sold in the United States). According to the Swedish testers at Teknikens Varld, Ford's electric car not only failed to hit the speed necessary for a passing grade, it didn't perform well at slower speeds, either. To pass the outlet's moose test, a car has to complete a rapid left-right-straight S-shaped pattern marked by cones at a speed of at least 72 km/h (44.7 miles per hour). The test is designed to mimic the type of avoidance maneuver a driver would have to take in order to avoid hitting something that wandered into the road, which in Sweden may be a moose but could just as easily be a deer or some other member of the animal kingdom elsewhere in the world, or possibly a child or car backing into the motorway. Not only is the maneuver very aggressive, it's also performed with weights belted into each seat and more weight added to the cargo area to hit the vehicle's maximum allowable carrying capacity. The Mustang Mach-E only managed to complete the moose test at 68 km/h (42.3 mph), well below the passing-grade threshold. Even at much lower speeds, Teknikens Varld says the Mach-E (which boasts the highest carrying capacity and was therefore loaded with more weight than the rest of the vehicles tested in this quartet) is "too soft in the chassis" and suffers from "too slow steering." Proving that it is indeed possible to pass the test, the Hyundai and Skoda completed the maneuver at the 44.7-mph figure required for a passing grade and the Tesla did it at 46.6 mph, albeit with less weight in the cargo area. It's not clear whether other versions of the Mustang Mach-E would pass the test. It's also unknown if Ford will make any changes to its chassis tuning or electronic stability control software, as some other automakers have done after a poor performance from Teknikens Varld, to improve its performance in the moose test. Related video:

NHTSA closes Ford F-150 EcoBoost acceleration probe

Typically when we report on the findings of an investigation from the National Highway Traffic Safety Administration, it's because the government body has discovered a safety issue and prescribed a recall. In this case, however, NHTSA has closed an investigation into a reported performance deficit without ever getting to the recall stage.
The issue revolves around the Ford F-150 - specifically those equipped with the 3.5-liter EcoBoost engine - of which some 360,000 were built in the 2011, 2012 and 2013 model years. After receiving an initial 95 complaints, NHTSA opened an investigation last May - almost a year ago - into the reported issue of reduced engine power under hard acceleration. The agency has since received a total of 525 such complaints, and Ford itself reported receiving over 4,000.
Together, NHTSA and Ford determined that the problem resulted from cylinders misfiring, an issue itself stemming from water getting into the charge air cooler (CAC) mated to the turbochargers. In particularly humid or rainy conditions, water was found to get into the CAC, causing some of the cylinders to misfire, which in turn triggered the ECU to disable those cylinders in order to protect the catalytic converter from damage.

Ringbrothers drops more hints about its wild SEMA creations

Ringbrothers isn't finished teasing its SEMA creations. First we got a sliver of rear quarter on a 1969 Chevrolet Camaro that revealed a bundle of carbon fiber and SEMA-obligatory deep-dish wheels. The Wisconsin tuner's now announced its litter of cars headed to the show and a few specs, along with two shadowy drawings. The Camaro, christened with the name Valkyrja and a two-tone paint job, gets stretched in two directions with severe fender flares to widen the body and an extended wheelbase. We're not sure what's happening with the Camaro's snout in the drawing, but under that bulging hood we'll find a 416-cubic-inch LS V8 from Wegner Motorsports. Wegner built the 416-cu-in supercharged LS3 V8 that powered Ringbrothers' 1,000-hp G-Code Camaro in 2016.  The second member of the gang is a 1969 Ford Mustang Mach 1 dubbed Unkl. The exterior begs for attention with a deep blue sea paint job, deep front chin spoiler, bulging hood, yellow brake calipers, and what looks like a racing number inside a roundel on the doors. Unkl gets its motivation from a 520-cu-in Boss V8 built by Kaase Racing Engines, rumored to throw about 800 hp.    Finally, Ringbrothers is bringing its Cadillac Madam V for another Las Vegas go-round after giving the custom coupe some updates. The Madam V is a 1948 Cadillac Series 62 fastback coupe body placed atop an ATS-V chassis, first shown in 2016. The firm didn't elaborate on the changes, so all we can expect for now are the coupe's postwar good looks mixed with new-millennium engineering, and a 3.6-liter twin-turbo V6 with 464 hp under that exceptionally long hood.    For any in attendance at the show, the Valkyrja Camaro debuts at the BASF booth on Tuesday, Nov. 5, 2019 at 9:30 a.m., the Unkl Mustang gets revealed a couple hours later at the Flowmaster/Holley booth, and the Madam V Cadillac will be on display throughout the show at the Ringbrothers booth.