2002 Ford F-150 Harley Davidson Supercharged Crew Cab 4 Door Truck Custom Tan on 2040-cars

Auto blog

2015 Ford Mustang EcoBoost loses big power on 87 octane

The 2015 Ford Mustang with the 2.3-liter EcoBoost four-cylinder is a pretty potent package on paper. With 310 horsepower and 320 pound-feet of torque, it boasts better performance numbers than the 3.7-liter V6, but with better fuel economy as an added benefit. However, if you're in the market for one of these boosted 'Stangs, you should probably keep in mind that it really prefers to gulp premium, 93-octane fuel. It can drink 87-octane swill in a pinch, but you're going to find significantly less power underfoot when pulling away. While it's not shocking that the ponies are dialed back with a lower grade of gasoline, an alleged page from a Ford training manual obtained by Mustang 6G purports to show just how much power is lost, though. According to this document, the 2.3-liter EcoBoost makes 275 horsepower and 300 pound-feet of torque when running on lower octane fuel. That's a substantial reduction of about 11.3 percent compared to when the engine drinks 93 octane. Interestingly, according to Mustang 6G, that finding was a bit better than expected, because a Ford engineer reportedly said power would be down about 13 percent without altering peak torque. In speaking with Autoblog, Paul Seredynski of Ford powertrain communications, objected to part of this document. While he couldn't confirm the specific losses listed for the Mustang EcoBoost, "torque remains unchanged" with lower octane gasoline, Seredynski said. He speculated this training manual page was "possibly from before the engine was certified" and therefore showed incorrect figures. Serendynski did confirm that the automaker recommends using 93 octane, and like all modern engines, the software adapts if it's lower. "Peak power would be reduced" by using a lesser grade, he confirmed. Featured Gallery 2015 Ford Mustang EcoBoost: First Ride View 20 Photos News Source: Mustang 6GImage Credit: Copyright 2015 AOL, Ford, Mustang 6G Ford Technology Convertible Coupe Performance ecoboost ford mustang ecoboost

Ford, Samsung shack up to bring regen braking to non-hybrid models [w/video]

Ford must be desperate to get itself ready for the beach this summer because it is really trying to get into shape. Shortly after unveiling the Lightweight Concept that cut the weight of a Fusion down to that of a Fiesta, it's now the rest of the line's turn for improvement. The company is wrapping up a 10-year research project aimed at developing next-gen automotive batteries to improve efficiency.
Ford claims that 70 percent of its lineup will have stop/start tech by 2017. The key to this massive proliferation is its new dual-battery system that combines a lithium-ion battery with a lead-acid one and regenerative braking. The setup works by harvesting braking energy and converting it to electricity. When the vehicle stops, the engine shuts off, but the Li-ion battery has enough juice to keep the accessories running. The engine starts up again as drivers take their foot off the brake. The layout would mean less wasted gas while idling. It's already available on Ford hybrids and is somewhat similar to the i-Eloop capacitor-based system from Mazda.
The bigger challenge is tuning the regenerative braking right. While hybrid drivers may be a little more adventurous, when it comes to getting a hang of regen braking, conventional buyers might not be so open-minded. The systems have a tendency to be a little grabby at first and then taper off at very low speeds. Ford needs to make sure it's just right to avoid turning off buyers.

Ford running short of F-150 frames

Like most any automaker, Ford is eager to build as many F-150 pickups as it can sell. And considering that the truck has long stood as the top selling vehicle in the United States, that means building (and selling) a lot of them. Further, Ford reports that its factories are finally fully up to speed and ready to build as many F-150s as dealers can sell. Unfortunately another factor is reportedly preventing the new aluminum-bodied pickup from reaching its potential. According to Automotive News and as we've heard before, the Blue Oval automaker has had trouble getting its hands on as many frames as it needs. Though Ford would not confirm the shortage itself, AN cites union sources in reporting that the Metalsa plant in Kentucky, which produces the new F-150's frame for Ford, has been unable to meet the demand for more such frames. "Whenever you have launches, you have issues that you have to deal with in the supply base," is all Ford CFO Bob Shanks would admit. "We're always working closely with suppliers if there's an issue to sort it out. If that were the case, that's what we'd be doing." The reported supply shortage could be why plans for overtime production are reportedly being canceled at both the plants in Kansas City and Dearborn where the F-150s are assembled, despite reaching or nearing full capacity. The shortage could also help explain why, according to AN, sales of the F-Series in the United States fell nearly 10 percent last month, while the rest of the pickup market rose 17 percent. Related Video: