Beautiful Caribbean Turquoise, 422 Cid Tri-power, C6 Automatic, Cold Ac, Ready on 2040-cars

Auto blog

A tribute to William Clay Ford

The passing of William Clay Ford has been a big event for the company he spent most of his life helping run. Ford spent 57 years working for his family's company. Considering the Blue Oval has been around for over 100 years, WCF's passing is the end of an era for the Dearborn-based manufacturer.
Ford's YouTube channel has issued a short memorial video highlighting the life of the longest-lived grandson of company founder Henry Ford. It follows William Clay from his time as a boy, showing him alongside his grandfather, through his younger years, and into his twilight, as the patriarch of the Ford family.
Take a look below for this touching memorial video on William Clay Ford.

Ford opens the doors on its Swedish rally skunkworks

It's always amazing to see how different kinds of racecars are made. Formula One racers are often constructed in modern architectural marvels that hint at some of the cutting-edge technology going into the racing. Conversely, rallying is all about sliding around on a varied course as fast as possible, but it often leaves a vehicle caked in mud. So it makes some sense Olsbergs MSE, or simply (OMSE) rally car shop in Nynashamn, Sweden, shows technological sophistication in a more down-to-earth setting. It builds Ford Fiesta ST racers for Global Rallycross there, and this new video gives viewers a tour through the work.
Former rally driver Andreas Eriksson runs OMSE. These days instead of racing, he and the company's 46 employees are building Ford racers from scratch. A ton of work goes into constructing each one, and according to Eriksson, it takes 400 hours to complete each body. At times, things are so busy that some of the technicians live in the shop in apartments that are on premises. There's even a restaurant to keep them fed. Sadly the dyno room is empty during this visit, though.
By the time OMSE is done, a rallycross car might resemble a Fiesta ST on the outside, but as you see in the video, it's a completely different beast underneath. Check out the work it takes to build one of them, and scroll down to read more about it in the official release.

How the 2015 Ford Mustang will save your knees

The 2015 Mustang is one of the most hotly anticipated vehicles of the moment, and Ford continues to leak out interesting little details about its newest pony car. The latest info doesn't have anything to do with its quarter-mile time or handling, but if any of that goes drastically wrong, the innovative new glovebox-mounted airbag may prevent passengers from knee injuries.
All variants of the 2015 Mustang get the active knee airbag as standard, and it's the first vehicle in Ford's lineup to receive the system. The setup is actually quite simple and ingenious. The glovebox is made from a plastic outer panel that is attached to the inner door. Sandwiched between them is this new injection-molded plastic bladder that folds flat when in use. If the passenger-side airbag deploys, the system springs into action to act as a cushion for your knees. Compared to a traditional knee airbag that has to fully inflate, this arrangement is 65 percent lighter and can use a 75 percent smaller inflator. It's also basically invisible when you look at the glovebox door.
Ford spokesperson Ed Saenz declined to tell Autoblog whether the system will appear in other vehicles in the Blue Oval's lineup but said, "We're considering other applications." Provided it's effective, the approach seems too simple not to make its way to other products. Scroll down to watch a video showing how the glovebox-mounted knee airbag works.