Sport New Suv 3.5l Cd 4x4 Turbocharged Tow Hitch Power Steering Abs Brake Assist on 2040-cars

Auto blog

Shelby to auction 2012 GT350 No. 1 in Vegas

With Shelby preparing to wind down production of its brutal GT350, a 624-horsepower Mustang that's meant to go up against the Roush Stage 3 in the world of tuned Ford ponycars, the Las Vegas-based tuner is looking to give back to one lucky customer. It'll auction off the very first GT350 ever produced, at the 2013 Barrett-Jackson auction in Las Vegas, a three-day event that runs from September 26 through September 28.
The GT350 is a monster, with a 5.0-liter, supercharged V8 that's been tuned well past 600 horsepower in a time when Ford's own Shelby-branded GT500 barely reached 550 horsepower. The GT350 is much louder than Ford's effort, too, both visually and audibly. The wide body look isn't what we'd call conventional, but on a car that sounds and goes like this, something extreme is needed. According to Shelby American's vice president of production, Gary Davis, "Carroll was very excited about the new wide body option, so that was included on this car. It's the first 2012 GT350 serial number from our anniversary year. It is a very special car." Wilwood brakes, a massaged suspension, and some very fat, sticky tires add to the Shelby experience.
This particular GT350 will be lot number 750, and will cross the Barrett-Jackson stage on Sunday, September 28.

Ford family keeps special voting rights

Ford Motor Company has a dual-class stock structure of Class A and Class B shares. The roughly three billion Class A shares are for the general public like you and me, while the roughly 71 million Class B shares are all owned by the Ford family. Each Class A share gets the shareholder one vote, each Class B share is worth 16 votes, the result being that Common Stock holders control about 60 percent of the company while the Ford family controls 40 percent even though it holds far fewer shares. The only way that could ever change would be if the Fords sell their Class B shares, but even so, Class B shares revert to Class A when sold outside the family, so they'd have to sell a whole bunch of them.
A contingent of Class A shareholders think the dual-class system is unfair, and for the past few years a vote's been held during the annual shareholders meeting to end it. It has failed every time, as it just did again during the meeting held this week. A smidge over 33 percent voted to end the dual system, outvoted by the 67 percent who are happy with the way Ford is going - unsurprising in view of a corporate turnaround that will be part of business-class curricula for years to come.
On the sidelines, Ford elected Ellen R. Marram to the post of independent director, the first woman to hold the job. The former Tropicana CEO and 20-year Ford board member replaces retiring board member Irvine Hockaday who helped bring Alan Mulally to the CEO position.

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).