Excellent Condition 2006 Ford Expedition Eddie Bauer Sport Utility 4-door 5.4l on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

2020 Toyota Highlander vs other 3-row crossovers: There can only be one!

We've done quite a few spec comparison posts involving three-row family crossovers, and when included, the Toyota Highlander has always been the runt of the group. While the rest increasingly seemed to be benchmarking each other toward greater girth, the Highlander was the outlier.  That changes a bit for the 2020 Toyota Highlander, but only a bit. It's now larger and more competitive, specifically in regards to the amount of cargo space aft of the third-row seat. As you can see below, this aligns the Highlander most closely to its long-time competitor the 2020 Honda Pilot. However, let's see how it stacks up to others in the segment, which is heavily populated now, so for the sake of space, we've selected the newest entries: Kia Telluride, Hyundai Palisade, Subaru Ascent and Ford Explorer. The order in which they are presented is random.  Performance and fuel economy The 2020 Highlander is more than 200 pounds lighter than its predecessor, but has the same 295-horsepower V6 engine that was already one of the strongest in the segment. We'd say that would give it a leg up, but the Pilot and Explorer have proven to be sprinters, delivering 0-60 times in the low-6 range by some publications' stopwatches (or VBoxes, whatever). We don't expect the Highlander to beat them, but it may dip into the 6's. The heavy, less-powerful Subaru Ascent is most likely to take up the rear. It's fuel economy of 23 mpg combined also matches the Highlander and Explorer for segment-best. Remember, however, that the Explorer's turbocharged inline-four engine is likely more susceptible to differences in driving style (read: a heavy foot).  Of course, if you're really interested in fuel economy, the Highlander and Explorer are the only vehicles in the segment to offer hybrid versions. The Ford Explorer Hybrid puts a greater emphasis on performance, however, resulting in lower estimates of 25 mpg combined (AWD) and 28 mpg combined (FWD). By contrast, the new 2020 Toyota Highlander Hybrid is estimated to return 36 mpg combined.  Passenger and cargo space According to Highlander chief engineer Yoshikazu Saeki, he had a choice of two directions with the new Highlander. He could have indeed made it bigger, matching these very competitors, especially in terms of third-row and cargo space. Or, he could have maintained a smaller-than-average size. He obviously chose the latter. First, it was the size customers had come to expect. Would they be put off by something bigger?

How Chevy Silverado, GMC Sierra will take on the Ford F-150 profit machine

FORT WAYNE, Ind. — When General Motors engineers were developing the 2019 Chevrolet Silverado and GMC Sierra pickup trucks, some of them joined public tours of Ford's Dearborn, Mich., factory to watch aluminum-bodied F-Series trucks go down the assembly line. The redesign of the Ford F-Series trucks, launched in 2014, set a new standard for fuel economy and lightweight vehicle construction. But armed with stopwatches and trained eyes, the GM engineers believed they saw problems. "They had a real hard time getting those doors to fit," Tim Herrick, the executive chief engineer for GM truck programs, told Reuters. His team did more intelligence gathering. They bought and tore apart Ford F-Series doors sold as repair parts. Their conclusion: GM could cut weight in its trucks for a lower cost using doors made of a combination of aluminum and high-strength steel that could be thinner than standard steel, shaving off kilograms in the process. These pounds-and-pennies decisions will have major implications in the highest-stakes game going in Detroit: dominance in the world's most profitable vehicle market, the gasoline-fueled large pickup segment. What's more, GM is banking on strong sales of overhauled 2019 Silverados and GMC Sierras to fund its push into automated and electric vehicles — a business many investors see as the auto industry's long-term future. The risks are high given the hits automakers have taken from U.S. President Donald Trump's trade policies. Rising aluminum prices spurred by Trump's tariffs are driving up costs on the Ford's F-Series, while rising steel and aluminum prices likewise drag on GM results. GM also has a significant risk should the United States, Mexico and Canada fail to agree on a new NAFTA trade deal, given GM trucks built at its Silao, Mexico, factory could face a 25 percent tariff if NAFTA collapses. Major profit per truck Interviews with GM executives and a tour at its factory here in northwest Indiana provide a detailed look inside GM's plan for the most important vehicles in its global lineup. These big pickups are everything Tesla's Model 3 or Chevy's Bolt electric car is not. The mostly steel body is bolted to the truck's steel frame, rather than the one-piece body and frame electric vehicles. The majority of trucks will have a V-8 gasoline engine powering the rear wheels — like the classic GM cars of the 1950s. Some Silverados will have new four-cylinder engines, but there is no electric or hybrid offering as of now.