Eddy Bauer, Custom Expedition, 24 Inch Wheels, on 2040-cars

Auto blog

Ford Fiesta ST gets worked out on the track

We're big fans of the turbocharged Ford Focus ST, and we're plenty excited that the Blue Oval will be offering a similar treatment on the smaller Fiesta here in the United States, too. We first saw the production-ready Fiesta ST five-door at the Los Angeles Auto Show last fall, and Ford has now released this video of a Euro-spec three-door ST being flung around the track.
But not just any track - the challenging Track 7 of Ford's Lommel Proving Grounds in Belgium. The course features 20 turns and plenty of elevation changes along its 2.7-mile loop, and David Put, a vehicle dynamic specialist at Ford, shows just how good the pint-sized Fiesta ST is at handling the lot, even getting the smallest ST up on three wheels every now and then.
It sure does look like a lot of fun, and makes us really eager for our chance to try this ourselves. Scroll down to see the hot little Ford getting busy.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford will put solid axles under the Bronco as the off-roading gods intended

We've been wondering what sort of creature the Bronco would be since we first heard of the thing last October, when a union chairman spilled the beans on the SUV and the Ranger pickup. Ford confirmed a 2020 arrival date for the Bronco at the 2017 Detroit Auto Show, but at that point pretty much all we were sure of was that the Ranger and Bronco would be returning. The open question would be how hungry Ford was to spoil the Jeep Wrangler's solo party as a compact(ish) off-roader with dual solid axles, since the easiest thing would be to carry over the suspension design of the presumably related international Ford Ranger and its Everest SUV version: independent front suspension with either a leaf- (Ranger) or coil-suspended (Everest) solid rear axle. Enter Dana, the long-time supplier of Jeep stick axles, to confirm that the 2020 Bronco is getting a pair of them. That means solid axles front and rear, just like under a Wrangler. So reports Automotive News, citing an investor presentation from Dana. All signs so far, such as the report that the Bronco would be engineered by the same team in Australia that created the Ranger pickup, indicated that the Bronco would share a platform with the Ranger and thus be body-on-frame. The solid axle confirmation essentially confirms that theory. Some off-road-capable vehicles have paired solid axles with unibody frames, like the Jeep Cherokee (XJ generation) and Grand Cherokee (ZJ and WJ generations), but they are outliers. Generally, if you've got solid axles at both ends, they're going in a vehicle with a ladder frame. It also lends credence to the notion that our Bronco won't simply be an imported Everest, which might be too understated to stand out from lesser crossovers anyways. This is good news if you have Blue Oval in your blood and pine for a modern SUV that'll show up the Jeep guys on the trail. Less directly, it could mean a wholesale assault on the formula that makes Jeeps successful in the first place: the massive aftermarket of off-roading equipment and dress-up bits that appeal to Jeep buyers almost as much as a Trail Rated badge. At a minimum, Bronco enthusiasts can breathe easy that the reborn SUV won't merely be a light-duty crossover with styling "inspired" by true off-roaders. There's still a lot left to learn about the Bronco. Keep up to date with our running summary of everything we know about the returning off-roader.