2004 Ford Excursion Xlt Sport Utility 4-door 5.4 Triton, 4 Wd, No Reserve, L@@k on 2040-cars

Auto blog

Shelby GT350R offers first mass-produced carbon fiber wheels

In the world of race engineering, reducing total weight is good, but reducing unsprung weight is flippin' fantastic. That's the reason Ford is pushing the envelope in terms of technology for the Shelby GT350R's wheels. Joining the likes of Koenigsegg in the offering, Ford has teamed with Australian outfit Carbon Revolution to produce the CF rollers en masse for the first time. Destined for the hubs of the new Shelby GT350R, the new hoops weigh just 18 pounds each, versus the 33-lbs weight of a similar aluminum wheel. On top of slashing up to 60 pounds in unsprung weight, there's such a reduction in rotational inertia – 40 percent, versus aluminum wheels – that Ford actually has to recalibrate the magnetic ride control system and springs. Thanks to, we're guessing, scenes of crashed Formula One cars disintegrating and spewing shards of carbon fiber all over the track, Ford seems quite keen to do away with the idea that CF is strong, but brittle. The company conducted extensive shock testing, ramming a wheel into a curb at speed. According to the Blue Oval, the lightweight wheel allowed the suspension to respond so quickly that the impact was "greatly diminished," causing the tester to run the experiment again, thinking there'd been a mistake. After recording brake rotor temperatures of 900 degrees Celsius (over 1,650 degrees Fahrenheit, or well past the point that aluminum or magnesium would melt) during testing, Ford and Carbon Revolution actually redesigned the wheels to "a thermal standard more suitable for motorsports," by adding an "incredibly thin, nearly diamond-hard coating that reliably shields the resin from heat." The same process was used to protect engine turbine blades on the Space Shuttle. While the work by Ford and Carbon Revolution should make GT350R customers excited, the work being done here could have serious implications for performance cars in the future. That's the real takeaway here, and is something that should leave fans of all performance vehicles excited.

Recharge Wrap-up: DriveNow in Brussels, DOE funds H2 projects

The DriveNow carsharing service – a joint venture between BMW and Sixt – has expanded to Brussels, Belgium. In addition, 20 percent of the entire DriveNow fleet is now made up of electric vehicles, and more than 150,000 of the service's 600,000-plus customers have had their first EV driving experience through DriveNow. Users in most of the 10 cities in which the program operates have access to the BMW i3, which have been part of the fleet since 2013. Read more from Green Car Congress. The US Department of Energy (DOE) is providing more than $13 million in funding for the advancement of hydrogen and fuel cell technologies. The DOE's Fuel Cell Consortium for Performance and Durability (FC-PAD) will help fund projects from General Motors, 3M, the United Technologies Research Center, and Vanderbilt University to reduce the use of platinum and increase the performance and durability of fuel cells. The DOE's Hydrogen Materials—Advanced Research Consortium (HyMARC) is funding hydrogen storage projects by Argonne National Laboratory, Penn State, University of Hawaii, Manoa, and University of Missouri, St. Louis. Read more from the DOE. The Advanced Diesel-Electric Powertrain (ADEPT) program's 48-volt lead-carbon battery will help next-generation cars meet future emissions requirements. ADEPT, of which Ricardo, Ford, and the Advanced Lead Acid Battery Consortium (ALABC) are partners, will present its results at the Cenex LCV2016 low-carbon vehicle conference at Millbrook on September 14 and 15. The "intelligent electrification" mild hybrid system will be showcased in a Ford Focus demonstration car. The system provides fuel efficiency and CO2 emissions benefits comparable to that of a full hybrid diesel powertrain, but at a lower cost. In addition to the lead-carbon battery (which is lithium-free and easily recyclable), the mild hybrid powertrain uses a Ford ECOnetic 1.5TDCi engine, advanced belt starter generator, and Turbine Integrated exhaust Gas Energy Recovery System (TIGERS). Read more in the press release below. Hybrid vehicle with 48V advanced lead carbon battery on path to meet future ultra-low emissions targets · ADEPT programme aims to demonstrate technology capable of providing near full-hybrid equivalent fuel economy at significantly lower cost · UltraBattery® advanced lead-carbon battery pack, provides a high power, high endurance, easily recyclable, lithium-free low-cost energy storage solution.

2015 Gordon McCall's Motorworks Revival

Considered the big kick off of the major festivities surrounding Monterey Car Week, this year's Gordon McCall's Motorworks Revival certainly didn't disappoint. For those unable to make it to the California coast, our own Drew Phillips was on hand to snap some of the beautiful vehicles on display for this gorgeous gallery. Held annually at the Monterey Jet Center, the event is always a feast for the eyes by collecting planes, a gang of exotic supercars, and some the top cars crossing the auction block over the coming days, like a Plymouth Hemi 'Cuda convertible. The Ford GT both new and old was a major attendee at this year's party. Among them, the Petersen Museum brought along an original racecar and a GT40 MKIII to promote an upcoming exhibit. The classics were complimented by the latest version that has continued to keep tongues wagging. The GT wasn't the only classic with a modern update there. Singer used the posh event for the North American debut of its stunning restoration of the Porsche 911 Targa. Shelby American was also at the revival for the public unveiling of the 50th Anniversary Daytona Coupe. On the more modern front, Honda was in attendance with the future NSX and one of the McLaren F1 cars that the company's engine powers. For further proof of the ritzy folks that attend this soiree, Pagani and Koenigsegg both had stands to show off their extremely quick wares.