2000 Ford Excursion 5.4 on 2040-cars

Auto blog

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Trump takes potshots at Ford in Flint

Doubling down on his general dislike of everything south of the Rio Grande, Republican presidential hopeful Donald Trump took aim at local favorite Ford during his first campaign visit to Michigan yesterday. "Ford is building a $2.5 billion plant in Mexico," Trump told a standing-room-only crowd in Birch Run, MI, yesterday evening. "I'll actually give them a good idea. Why don't we just let the illegals drive the cars and trucks right into our country?" This is not the first time real estate mogul turned reality TV star has whined about Ford's Mexican factory plans. Previously, he promised that if he were elected, he'd levy a 35-percent tax against Mexican-built Fords. Then, as he has here, Trump failed to address other automakers selling Mexican-built vehicles in the US, including Detroit-based General Motors as well as foreign brands like Volkswagen, Nissan, and Toyota. "I would say, the deal is not going to be approved, I won't allow it. I want that plant in the United States, preferably here," Trump said, with Bloomberg reporting his comments were meant with chants of "USA." Ford announced the $2.5-billion Mexican investment in April, saying it'd build two factories to produce transmissions and engines. In response to Trump's criticism of the deal, the Dearborn-based automaker was quick to point out that it hasn't exactly been stingy about building its business here in the US. "We are committed to leveraging our global manufacturing footprint and will continue to invest where it makes the best sense for our business," Ford spokesman Karl Henkel told Bloomberg. "We are proud that we have invested $6.2 billion in our US plants since 2011 and hired nearly 25,000 US employees." Related Video:

Ford Mustang GT500 successor spied near SVT

Details about the next-gen Ford Mustang are scarce, and there's even less information out there about the upcoming replacement for the Shelby GT500. Previously rumored to drop the Shelby name and wear the GT350 moniker, the highest-performance Mustang has just been spotted testing near Ford's SVT operations.
Despite being cloaked in heavy camouflage, we can instantly tell this prototype is different from other Mustang spy shots we've seen in the past. Aside from the Shelby-spec wheels, quad exhaust outlets (previous spy shots show only two) and beefier brakes, this car also has air intakes on the hood and front fenders. These elements help to neither prove nor dismiss rumors that the next SVT Mustang will be naturally aspirated. It also looks like Ford is may be planning some changes to this car's rear suspension, as there is some extra camouflage added beneath the rear end of this prototype.
As a bonus, these spy shots also give us our first look inside the new Mustang, revealing a new steering wheel (with more buttons) and a glimpse of the dual-pod instrument gauges. Check out past spy shots of the 2015 Mustang showing off its new face and driving around town.