Clean Carfax Power Driver Seat Power Windows Front Wheel Drive 3.0l V6 on 2040-cars

Auto blog

1969 Ford Talladega GPT Special is a SEMA showstopper

Rad Rides by Troy has unleashed upon the SEMA crowds this custom 1969 Ford Torino Talladega GT Special, and it's a beauty. The car calls to mind the classic Holman Moody stock cars that circled NASCAR tracks in the late 1960's, driven by the likes of Mario Andretti, Dan Gurney and David Pearson, who won the Grand National title in both 1968 and '69 in a Ford Torino.
Even though it has plenty of stock-car influence, there's nothing retro about the car's design or powertrain, other than the fact that the engine is based on a Ford Boss 429 block. Fuel injection, aftermarket aluminum heads and a high-tech custom computer system combine to send 750 reliable ponies to the rear wheels through a Tremec five-speed manual transmission. Brakes measure 14-inches all around, with six-piston Wilwood calipers up front and four-piston units out back.
There's custom bodywork abound, painted in a two-tone Tennessee Whiskey Gold and Daytona Sand finish. Check out all the amazing details in the image gallery below, and scroll down to read all about it in designer Troy Trepanier's own words.

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Why Edmunds took a sledgehammer to its 2015 Ford F-150

The discussion around repair bills for the aluminum-bodied 2015 Ford F-150 pickup continued from the beginning of last year to the end, and haven't abated; as an aside, some Tesla Model S owners have been shocked at disquieting repair estimates for minor damage to their aluminum wunder-sedans. Edmunds decided to inject some fact into the fray: it bought a $52,000 long-term 2015 F-150 and clouted it with an eight-pound sledgehammer. Twice. The rear of the bedside took the impacts since it couldn't be replaced, it would have to be repaired. To the pickup's credit, the only reason associate editor Travis Langness hit it twice was that the first sledgehammer blow didn't do as much damage as Edmunds wanted. After the second, the visible damage included the two direct impacts, a few creases, and a cracked taillight, so they drove the pickup to Santa Monica Ford to get an estimate, complete with a fictitious story about how the damage occurred and the mercy plea that Langness was paying for the repair out-of-pocket. In Part 2 Langness hits on some of the details with getting the truck fixed, such as the massively expensive taillight and the list of tools Ford recommends dealers have to work on aluminum. But he was promised he'd have his truck back in seven days, and Santa Monica Ford got it back to him in seven days. In Part 3 we get the bill. It's not small, but it's quite a bit less than it could have been if the service manager had charged Edmunds the official labor rate for aluminum. We're not going to spoil it here, so check out the videos above and below for the beginning and the end, and head over to Edmunds for the complete story about how it all happened and some riffing on the repair numbers. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Related Video: