2013(13)escape Sel Awd Fact W-ty Only 13k Heat Sts Lthr Phone Cruise Sirius Mp3 on 2040-cars

Auto blog

Next Shelby Mustang to wear GT350 nameplate

Earlier this month, rumors started to swirl 'round the web about the next-generation Ford SVT Mustang - the halo version of the all-new 2015 'Stang seen testing in the gallery above. Originally, we heard that the Shelby GT500 moniker would be dumped in favor of "a name you're familiar with," which some sources guessed could mean a return of the Cobra nameplate.
That might not be correct. According to Road & Track, citing a report from Mustangs Daily, the new range-topping Mustang will bring back the Shelby GT350 name - currently used on an aftermarket version of Ford's Pony produced by Shelby American (take a look at our recent Quick Spin of that car). Expect the new GT350 to be quite a bit different than the current GT500 - it will be all motor, using a V8 that's derived from the naturally aspirated 5.0-liter Coyote engine (though it will no doubt have a higher displacement). The GT350 will be a lot more powerful than the next Mustang GT, which is expected to offer something like 450 horsepower, but won't be quite as absurd as the 662-horsepower GT500 we currently enjoy.
The Shelby GT350 will reportedly bow with the rest of the new Mustang range at the 2014 New York Auto Show, which coincides exactly with the original Mustang's debut at the New York World's Fair in 1964. If that seems far out, don't worry, we'll be seeing the rest of the 2015 Mustang range before then, but Road & Track reports that the 2014 Detroit Auto Show stage will be reserved for the reveal of the next Ford F-150 pickup.

NHTSA closes Ford F-Series Super Duty steering probe without recall

The National Highway Traffic Safety Administration's investigation into 2008 Ford F-250 and F-350 Super Duty pickups, which was originally opened last year, has now ended without a recall. NHTSA was looking into steering failures on some 336,000 trucks.
The issue rested with the steering gear - NHTSA received five complaints of failures - which was redesigned in 2005. According to the report on the matter, investigators "found evidence of broken sector shaft gear teeth and piston damage consistent with incidents of single event overload."
NHTSA investigators, however, "found no evidence of fatigue or material property defects in any of the fractures. Analysis of complaint rates by vehicle build month showed no patterns indicating potential manufacturing quality issues and no difference before and after Ford introduced design changes to the input shaft and sector shaft seals in July 2007 to address potential leak concerns," according to the report, obtained by The Detroit News.

Automakers' rush on aluminum may result in shortage

Aluminum is the new buzzword in the automotive industry. The latest Range Rover and Range Rover Sport both take advantage of the lightweight material to shave huge amounts of body fat (only it's called "aluminium" over there). Audi and Jaguar have been using the stuff for years in their A8 and XJ, respectively, and now, aluminum is going mainstream, arriving on the 2015 Ford F-150.
While we're excited to see aluminum make an impact outside the premium market, its widespread adoption apparently won't come without some problems, notably in terms of supply. "There isn't an automotive manufacturer that makes vehicles in North America that we're not talking to," Tom Boney, of Novelis, the largest global supplier of aluminum sheetmetal, told The Detroit News.
According to Boney, Ford's use of aluminum on such a large scale has forced auto manufacturers in "every boardroom" to reconsider their plans following the F-150's unveiling, for one simple reason: there's not exactly enough aluminum to go around, at least in the short term. The auto industry presently only accounts for six percent of the aluminum sheet produced, but as the material is adopted by more and more brands, that figure is expected to swell to 25 percent within the next six years.