2013 Sel Ecoboost Sat Radio Keyless Entry Cruise 26k Low Miles We Finance! on 2040-cars

Auto blog

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Is this the 2017 Ford Fusion?

Thanks to the sharp eyes of an anonymous tipster, you're looking at what may very well be the 2017 Ford Fusion. We know Ford's midsize sedan is in line for a makeover, and judging by the spy shots we've already seen, the somewhat blurry photo above matches what we're expecting to see. Styling updates won't be major, which is probably wise considering how well-received the current car's overall look was when it debuted as a 2013 model. The most immediately obvious styling tweak is a more taut fascia, with a grille that's pulled wider and pointier than the current Fusion. A shapely pair of headlights flank that new grille, and at the lower corners, angular new blades that may or may not house driving lights are new decorations to the Fusion's face. We don't see any changes to the car's bodysides, and with just one angle to dissect, we'll just have to guess at what the next Fusion will look like from the rear. Take a good look at the image above and let us know what you think. Is this indeed the 2017 Ford Fusion, and if so, is it a step in the right direction? Related Video: News Source: Ford (PDF link) Design/Style Ford Sedan

NHTSA and Ford investigating steering issues in Crown Vic, Grand Marquis and Marauder

There may be more steering woes for the Ford Crown Victoria. The National Highway Traffic Safety Administration has opened a preliminary evaluation into the Crown Vic and Mercury Grand Marquis from the 2004 to 2007 model years and the Mercury Marauder for the 2004 and 2005 model years because the steering shaft can jam. The issue could potentially affect an estimated 500,000 vehicles.
According to the regulator, there is a possibility that the driver's side heat shield for the exhaust manifold can rust, dislodge, and then wedge into the steering shaft. If this occurs, it leads to a situation where the driver can no longer control the car.
NHTSA has received five complaints of this happening, including one alleged case with an injury. In that situation, the car was driving onto the highway, lost control and rolled over. One occupant was hurt in the accident.