11 White 4.6l V8 E150 Cargo Van *work Desk & Bins *power Group *speed Control on 2040-cars
Lake Worth, Florida, United States
Body Type:Minivan/Van
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Dealer
Number of Cylinders: 8
Make: Ford
Model: E-Series Van
Mileage: 83,736
Warranty: No
Sub Model: E-150 ULEV II *1 OWNER *PREFERRED EQUIPMENT PKG
Exterior Color: White
Interior Color: Gray
Ford E-Series Van for Sale
2005 e350 econoline v8 commercial chassis 5.8l ,step van box truck(US $19,995.00)
Braun ambulance year 2000 ford e-350 econoline(US $10,500.00)
2008 ford quigley four wheel drive conversion van
2012 ford e-150 wheelchair van(US $29,995.00)
2008 ford e350 luxury passenger van with 14 captain chairs 5.4l v8 auto(US $14,875.00)
1998 ford e250 cargo van, no reserve, no accidents, runs fine,
Auto Services in Florida
Zephyrhills Auto Repair ★★★★★
Yimmy`s Body Shop & Auto Repair ★★★★★
WRD Auto Tints ★★★★★
Wray`s Auto Service Inc ★★★★★
Wheaton`s Service Center ★★★★★
Waltronics Auto Care ★★★★★
Auto blog
Tanner Foust gets eponymous hotted-up Ford Focus ST from Cobb Tuning
Thu, 14 Mar 2013Racer and Top Gear USA host Tanner Foust has partnered up with Cobb Tuning to create a special-edition Ford Focus ST. The limited-edition hatches will come packing a reflashed ECU, special intercooler, tweaked intake and freer-flowing exhaust for up to 20 percent more power than the stock creation. Cobb says that the changes should push the final dyno figure to above 300 horsepower. Buyers can also expect to find special carbon fiber aerodynamic bits on board along with a new grille, graphics and wheels. Cobb hasn't released pricing on this Tanner Foust Edition Ford Focus ST as of yet, but you can bet the whole kit won't be cheap.
Fortunately, the company will sell you bits and pieces from the overall package for your Ford, and word has it engineers are also whipping up a Foust Fiesta ST. Look for Cobb's Focus ST website to go live next month, complete with accurate specs and pricing. Until then, enjoy clicking through the gallery here. You can also check out the full press release below.
Nuclear-powered concept cars from the Atomic Age
Thu, 17 Jul 2014In the 1950s and early 60s, the dawn of nuclear power was supposed to lead to a limitless consumer culture, a world of flying cars and autonomous kitchens all powered by clean energy. In Europe, it offered the then-limping continent a cheap, inexhaustible supply of power after years of rationing and infrastructure damage brought on by two World Wars.
The development of nuclear-powered submarines and ships during the 1940s and 50s led car designers to begin conceptualizing atomic vehicles. Fueled by a consistent reaction, these cars would theoretically produce no harmful byproducts and rarely need to refuel. Combining these vehicles with the new interstate system presented amazing potential for American mobility.
But the fantasy soon faded. There were just too many problems with the realities of nuclear power. For starters, the powerplant would be too small to attain a reaction unless the car contained weapons-grade atomic materials. Doing so would mean every fender-bender could result in a minor nuclear holocaust. Additionally, many of the designers assumed a lightweight shielding material or even forcefields would eventually be invented (they still haven't) to protect passengers from harmful radiation. Analyses of the atomic car concept at the time determined that a 50-ton lead barrier would be necessary to prevent exposure.
Ford running short of F-150 frames
Sun, Jun 7 2015Like most any automaker, Ford is eager to build as many F-150 pickups as it can sell. And considering that the truck has long stood as the top selling vehicle in the United States, that means building (and selling) a lot of them. Further, Ford reports that its factories are finally fully up to speed and ready to build as many F-150s as dealers can sell. Unfortunately another factor is reportedly preventing the new aluminum-bodied pickup from reaching its potential. According to Automotive News and as we've heard before, the Blue Oval automaker has had trouble getting its hands on as many frames as it needs. Though Ford would not confirm the shortage itself, AN cites union sources in reporting that the Metalsa plant in Kentucky, which produces the new F-150's frame for Ford, has been unable to meet the demand for more such frames. "Whenever you have launches, you have issues that you have to deal with in the supply base," is all Ford CFO Bob Shanks would admit. "We're always working closely with suppliers if there's an issue to sort it out. If that were the case, that's what we'd be doing." The reported supply shortage could be why plans for overtime production are reportedly being canceled at both the plants in Kansas City and Dearborn where the F-150s are assembled, despite reaching or nearing full capacity. The shortage could also help explain why, according to AN, sales of the F-Series in the United States fell nearly 10 percent last month, while the rest of the pickup market rose 17 percent. Related Video:
