California Custom Restored Classic Bronco 4x4 Automatic on 2040-cars

Auto blog

Ford recalls 1.48 million F-150s for transmission, plus other models

Weeks after recalling more than 800,000 F-Series pickup trucks for a fire risk, Ford has issued another separate recall for approximately 1.48 million 2011-2013 F-150s for a transmission fault. The six-speed automatics could unexpectedly downshift into first gear without warning. Ford and Lincoln tangentially issued much smaller recalls for the Mustang, Continental, Nautilus, and Navigator. According to Ford, some 2011-2013 model year F-150 pickups with six-speed automatic transmissions could "experience an intermittent loss of the transmission output speed sensor signal to the powertrain control module." This could potentially cause the trucks to temporarily downshift, which could be dangerous if it occurs while driving. Of the 1.48 million affected trucks, 1.26 million are in the U.S. while 221,000 are in Canada. Thus far, Ford knows of five reported accidents involving the issue. To remedy the problem, owners can take their trucks to dealers to update the power control module software. Ford also issued recalls for about 4,350 2019 Mustangs, Lincoln Nautiluses, and Lincoln Navigators in the U.S. and Canada due to a possible fault with the instrument clusters. Although there have been no reports of accidents, Ford says the instrument panel clusters assemblies might be blank or not turn out when the vehicle is started. Additionally, Ford issued a third recall for 28,200 2017-2019 Lincoln Continentals in the U.S. and Canada. Ford says silicon contamination might build up inside the door latch motor, causing it to malfunction. As a result, the door latch might not always fully engage, and the doors could possibly open unexpectedly. Despite no reports of accidents, Ford will remove and replace door latch assemblies on all doors for those affected by the defect. If any of these apply to a vehicle you own, contact Ford to discuss whether it is included in any of these recalls and have the vehicle checked out at a Ford dealership.

Ford recalls Explorer and Lincoln MKC for fire hazard

The Basics: Ford will recall 5,536 examples of the 2016 Explorer and 2015-2016 Lincoln MKC. The Explorers have build dates between October 20, 2014, and January 28, 2016, at the Chicago Assembly Plant. The MKCs are from between November 25, 2013, and January 25, 2016, at the Louisville Assembly Plant. In total, there are 3,129 total affected examples of the 2015-2016 Lincoln MKC and 2,407 examples of the 2016 Ford Explorer. Of these, 1,543 are in the US and 3,993 are in Canada. The Problem: The combination of the engine block design and the block heater in these vehicles can cause the part to overheat when plugged in. Injuries/Deaths: None reported, but there are two cases of underhood fires in Canada. If you own one: Ford will begin notifying owners during the week of May 16, company spokesperson John Cangany tells Autoblog. Related Video: Ford issues safety recall for certain 2015-2016 Lincoln MKC and 2016 Ford Explorer vehicles to replace engine block heaters Ford is issuing a safety recall for approximately 5,500 2015-2016 Lincoln MKC and 2016 Ford Explorer vehicles to remove the heaters and replace them with an updated design. The engine block design, coupled with the particular block heater installed in these vehicles, causes the unit to be susceptible to overheating when the vehicle is parked and the block heater is plugged in –increasing the risk of an underhood fire. Ford is aware of two reports of underhood fires in Canada, but is not aware of any accidents or injuries related to this issue. Affected vehicles include certain 2015-2016 Lincoln MKC vehicles built at Louisville Assembly Plant, Nov. 25, 2013 through Jan. 25, 2016 and certain 2016 Ford Explorer vehicles built at Chicago Assembly Plant, Oct. 20, 2014 through Jan. 28, 2016. There are 5,536 vehicles affected by the issue, including 3,129 2015-2016 Lincoln MKC and 2,407 2016 Ford Explorer vehicles, with 1,543 of the affected vehicles in the United States and federalized territories and 3,993 in Canada. Dealers will remove and replace the engine block heater with an updated design and, if needed, replace the cord at no cost to the customer.

Ringbrothers shows off Coyote-powered 1968 Mercury Cougar

We'll openly admit that not every SEMA build is our cup of tea. But this? A tastefully resto-modded 1968 Mercury Cougar with a 460-horsepower Ford Mustang V8? Yeah, this is right in our wheelhouse. Sadly, there was no in-pwerson SEMA show in 2020, so we missed out on gems like this one. SEMA or no SEMA, the aftermarket carries on, and co-owners Jim and Mike Ring of Ringbrothers (get it?) saw no reason to let their time and effort go to waste.  When they're not building wild customs (see: 1,100-horsepower 1972 AMC Javelin AMX) or more subtle showcases (such as this Cougar or their 1971 K5 Chevy Blazer build from 2018), the folks at Ringbrothers crank out factory reproduction parts, whether for old-fashioned restoration or modification purposes. While '60s muscle cars are recurring build subjects for the two, the Cougar was the first of its kind they tackled.  Keeping it in the family, Ringbrothers sourced a Ford 5.0-liter "Coyote" V8 and a 10-Speed Automatic (lifted from an F-150 Raptor, incidentally) for the build. They didn't stop with the driveline, of course. The suspension was overhauled with a little help from DSE and a set of HRE Series C1 C103 Forged 3-Piece wheels were thrown over upgraded brakes.  "We put our heart into each car we build, and this Cougar is no exception," Jim said. "The finished product is mild and classy, yet any enthusiast instantly knows it's not stock. I imagine this is what Mercury designers would have come up with if they were building the Cougar today." "While we couldn't bring the car to the SEMA Show, we hope it can be shown to the public soon," Mike said. "We had never done a Cougar before, so this was a fun build. I love working with new shapes and coming up with new ideas." There's plenty to appreciate about this Cougar apart from the mechanicals, too. The finish is Augusta Green Metallic (courtesy of BASF), which was a factory color in 1968. You may know it by another name: Highland Green. There are a few custom exterior touches, but they're quite subtle and styled to be period-correct. The interior was also restored and updated, and it's where you'll find the only thing we're not fond of: that big, fat truck shifter. Gearbox choices notwithstanding, it's a bit of an eyesore. But considering how gorgeous the rest is, we'll give it a pass.  Related Video: