Base New Manual Coupe 8.4l Nav Standard Srt V10 on 2040-cars

Auto blog

2019 Dodge Challenger R/T Scat Pack Widebody Drivers' Notes | Widebody for everybody

The 2019 and soon to be 2020 Dodge Challenger R/T Scat Pack Widebody is another Challenger dart thrown against the wall by Dodge. It takes the desirable Widebody package we’ve seen on Hellcats and applies it to the naturally aspirated Scat Pack with the 6.4-liter V8. This kit includes stiffer adaptive shocks, stiffer springs, larger stabilizer bars, big Brembo brakes, a 3.09 rear axle ratio, 20-inch forged wheels and massive 305 section-width tires on all four corners. Most important of all, you get the special Widebody fender flares that give the car its signature look. The package is $6,000 on top of a regular Scat Pack. That means the cheapest youÂ’ll step into a Scat Pack Widebody is $46,740. The Widebody that rolled through our offices came in at a much-higher $57,295 after a number of options were tacked on. Many of these, you can skip. The 485 horsepower and 475 pound-feet of torque that comes standard is the most important aspect of this big coupe. Several packages costing more than $1,000 each add convenience and driver assistance tech, and the Harman/Kardon system is a hefty $1,595. With such a loud engine and exhaust, itÂ’s hardly worthwhile. Our tester also had the $1,595 eight-speed automatic transmission. ThisÂ’ll let you scare unsuspecting bystanders with the remote start system, but opting for a manual is an easy way to save some cash and increase driver involvement. With all the modern technology like adaptive cruise control, auto high-beams, heated and cooled seats, and blind-spot detection, the Challenger tries its best to keep up with the times. ItÂ’s no technological marvel, but itÂ’s neat to see some of these options available for folks who might want them. Still, tech gizmos are not what the Widebody is about. This Challenger keeps the same personality as all of those before it, but adds a dash of handling and hostility to its outward appearance. Here are our varied experiences with it during a week of testing. Editor-in-Chief, Greg Migliore: Yes, you can put a rear-facing convertible car seat in a Dodge Challenger. I did. It actually wasnÂ’t that hard. Remember, the Challenger is genetically a Mercedes sedan and shares underpinnings with the Dodge Charger. The biggest hurdles are ingress and egress, which is to be expected in any coupe. The roofline is low, but really not that bad. I simply lifted my toddler and maneuvered him into the backseat.  I was able to get him secured and fastened, and then I just stepped out of the car.

Towing with the 2016 Ram lineup [w/video]

I do not tow things. Ever. Yet I recently found myself at the Fiat Chrysler Automobiles proving grounds in Chelsea, MI, where I'd be testing the hauling capabilities of Ram's current product range. This experience was not only a perfect education for a towing novice like me, but allowed me to tow far more weight than I'd ever consider hauling the real world, and all within the safe confines of the Chelsea Proving Grounds. There was an extremely diverse array of vehicles at my disposal, including Ram's gasoline- and diesel-powered offerings with trucks ranging from the 1500 on up through the 5500 Chassis Cab, as well ProMaster vans. Beyond that, FCA brought out a number of vintage Dodge pickups for me to play with, while also working with Case IH to provide a track-loader I could test. I put together a range of videos covering everything from the classics to the production trucks to the construction equipment. And despite some technical difficulties – you'll notice a distinct lack of in-car videos, with blame going to a corrupted micro SD card – I've assembled ten videos that give an up-close look at Ram's offerings. 2015 Ram ProMaster City Let's start small. The ProMaster City only has a towing capacity of 2,000 pounds. That's a reasonably impressive figure for a van that uses the same powertrain as a Chrysler 200. The 2.4-liter four-cylinder and nine-speed automatic weren't really bothered with the extra weight added by the trailer. Even when accelerating at freeway speeds, the ProMaster City didn't feel out of breath or hampered by its load. That said, the rear of the van was unloaded, which probably wouldn't be the case for most consumers. It's unclear how the City would feel if its driver were taking advantage of the max payload (1,883 pounds) and towing. 2015 Ram ProMaster 1500 To be polite, the Ram ProMaster is a difficult vehicle to like. Its awkward seating position is bus-like and lacks the visibility enjoyed by the Ford Transit or the utter driving comfort of the Mercedes-Benz Sprinter. Its 3.0-liter, four-cylinder turbodiesel engine, meanwhile, is something of an anomaly. While it's potent for a four-cylinder diesel, producing 295 pound-feet of torque and 174 horsepower, those numbers don't feel all that impressive when loaded down. The model I tested was barely using half of its 5,100-pound maximum towing weight and was loaded down with just 500 of its 3,620-pound payload. Yet it lacked the pluckiness of the smaller City.

Hellephant 1,000-horsepower Mopar crate engine priced, is available to order

The folks at Fiat Chrysler's Mopar division unveiled its meanest road-going V8 ever at last year's SEMA show. It makes 1,000 horsepower, and it's called the Hellephant in honor of the second-generation Charger's 426 "Elephant" V8, and because it has a honking big supercharger on top like the modern Hellcat. What we didn't know was the price, but now order books are open, and it's priced at $29,995. That's about $10,000 more than the currently available Hellcat engine, which makes 707 horsepower. You'll also probably want to buy the available kit that comes with all the computers, wiring, sensors and throttle to run it, and that's an extra $2,265. Putting things further into perspective, you can actually buy an entire new Dodge Challenger SXT V6 for $29,340. You'll also still need to add other accessories if you want things like air conditioning, which Mopar is also happy to sell you. What we're saying is, this is a lot of money just for an engine. But on the other hand, this is a roughly plug-and-play engine with Bugatti Veyron power for the price of a V6 Challenger, so that's pretty awesome. And you can put it into anything you have the skills or money to put it in. Plus, it should be able to make more power with higher-octane fuel. We can't wait to see the swaps and builds.