8k Miles, Only 360 Made, Gts Final Edition, New Tires, Just Serviced, We Finance on 2040-cars

Auto blog

Turn up the volume: Flat out in the Dodge Charger Scat Pack

The 2019 Dodge Charger R/T Scat Pack is a rare breed in the car market. It's a reasonably affordable large sedan with a huge honking V8 and rear wheel drive. You know, the perfect car for this Fourth of July. Or any day ending in Y, really. The R/T Scat Pack is the second most powerful version of the sedan with a 6.4-liter naturally aspirated V8 making 485 horsepower and 475 pound-feet of torque. Only the 707-horsepower Hellcat is a more powerful Charger. But power is only part of the story. The other part is the noise. The V8 has a gritty, dirty rumble to it. We recorded it cruising up on-ramps, down shifting, and got a few standing revs out of it. Check out the video to hear for yourself.

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

Chrysler extends fuel tank warranties on LX cars, NHTSA ends probe

The National Highway Traffic Safety Administration has ended its investigation of 153,817, 5.7-liter and 6.1-liter Hemi V8-powered 2006 Chrysler 300, Dodge Charger and Dodge Magnum models after reports of stalling. Chrysler has responded by granting a lifetime warranty on the fuel tanks for these vehicles.
NHTSA received 299 reports of engines stalling while the models were stopped or driving at low speeds, and began an investigation. The government agency found that the control valve shutoff float in the V8s' 19-gallon fuel tank could malfunction if the fuel had too high of an ethanol content. In many cases, the valve would break in the open position, allowing the tank to be overfilled, which would then cause the cars to stall. However, there were no accidents reported, and the vehicles could be restarted immediately.
There will not be a recall on these vehicles because, "the condition represents a low risk to motor vehicle safety and is adequately addressed by Chrysler's extended warranty," NHTSA said to The Detroit News.