2003 Dodge Viper Srt-10 Convertible 2-door 8.3l on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Jeep Grand Cherokee, Dodge Durango still catching fire after recall

Automakers issue recalls all the time. It's part of the cost of doing business. We just assume that once the recall has been carried out, the problem in question has been fixed. But that's not always the case, as this latest investigation being undertaken by the National Highway Traffic Safety Administration goes to show. The problem stems back to a recall issued by Chrysler last summer. It revolved rather the sun visor in the SUVs it makes at its Jefferson North Assembly Plant – specifically, the screw affixing the sun visor could end up rubbing against the wiring for the lamp in the vanity mirror, potentially causing an electrical short and even a fire. 62 such short circuits, 38 fires and three injuries reported, prompting Chrysler to recall nearly 900,000 units of the 2011-2014 Jeep Grand Cherokee and Dodge Durango (over 650,000 of them in the United States). The plastic spacers they installed to rectify the problem, however, may not have done the trick. Eight reports (but none involving injuries) have been filed with the NHTSA regarding the same issue recurring, spurring the government agency to open a new investigation into the matter. If deemed necessary, the NHTSA could ask FCA to issue another recall to fix the issue again, which we may necessitate the installation of a fuze to prevent any such the electric short. Related Video: INVESTIGATION Subject : Headliner Fires Date Investigation Opened: MAY 01, 2015 Date Investigation Closed: Open NHTSA Action Number: RQ15003 Component(s): ELECTRICAL SYSTEM , INTERIOR LIGHTING Manufacturer: Chrysler (FCA US LLC) SUMMARY: On July 1st, 2014 Chrysler (FCA US LLC) issued safety recall 14V-391 to remedy a wiring-related fire hazard on the headliner of approximately 661,888 model year (MY) 2011-2014 Jeep Grand Cherokee and Dodge Durango vehicles manufactured between January 5, 2010 and December 11, 2013. The recall was in response to the Office of Defects Investigation (ODI) investigation EA14-001 during which data provided by Chrysler indicates that the fire is caused by an electrical short in the vanity lamp wiring for either one of the sun visors mounted on the vehicle. The sun visors are mounted to the roof of the vehicle through the headliner with three metal screws.

The Dodge Demon's massive torque wrinkles its massive tires

Horsepower doesn't mean a damn thing if a car can't properly put the power down. That's why Dodge has fitted the upcoming Demon with some of the stickiest road-legal rubber available. Those Demon-branded Nitto NT05R drag radials skirt by regulations with just the smallest of margins, and in order to maximize the potential of the 315/40R 18 size tires Dodge increased the car's torque multiplication with a higher stall speed for the torque converter and a 3.09 rear axle. The 12.6-inch-wide tires are fitted to 18x11-inch wheels at all four corners, and they're fatter than those 305-section front tires on the Camaro Z/28 that we raved about years ago. Dodge says the combination of soft, gooey rubber and the new gear ratio gives the Demon about a 15 percent larger tire contact patch, more than twice as much grip, and roughly an 18 percent increase in both converter torque and rear-axle torque multiplication. Simply put, the Dodge Demon moves. You can see the results in the teaser video above, which is titles "Multiplication" and shows the crazy wrinkling of the sidewall that results from putting that torque to the road. We wouldn't be surprised if the inner rim of the wheel needs some grip to keep the tire seated, something Chevy had to do on the last Z/28. There is something wonderful about Dodge's approach to performance cars. While the Ford Mustang and Chevrolet Camaro have moved on from their muscle car upbringings with proper track-focused models, Dodge has stayed true to its roots by developing a machine that's sole intent is traveling a quarter-mile quicker than anything else on the road. Twisty roads may be fun, but there is something wholly and deeply satisfying about going deep into the accelerator with a comical amount of power at your disposal. We can't wait. Related Video: New York Auto Show Dodge Coupe Performance dodge demon dodge hellcat dodge challenger srt demon drag strip