2000 Dodge Viper Gts Coupe, 41k, Super Nice! Fast on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge celebrates centennial with Charger and Challenger 100th Anniversary Editions

In 1914, the Dodge brothers went from being a parts supplier to a full-scale automaker, and to celebrate the centennial of this milestone, Dodge will offer special editions of the 2014 Charger and Challenger early next year. Both cars will be sold in limited numbers (although no specific number was given), and these cars will stand out thanks to unique touches like 20-inch wheels, 100th anniversary edition logos and the exclusive High Octane Red Pearl Coat paint job (shown above).
The 100th Anniversary Edition package, which runs $2,200 on the 2014 Charger and $2,500 on the 2014 Challenger, comes with red or black leather seats with a cloud print (for a denim-like look) and metal badges on the seatbacks that read "Dodge Est. 1914," while similar logos are also found on the wheel center caps and front fenders. The instrument gauges are unique to each car, with the Charger getting black gauges and the Challenger getting white gauges, and to enunciate the 100-year anniversary, both cars have red numerals on the speedometer for the 100-mile-per-hour mark.
Finishing off the 100th Anniversary Edition cars, which will be offered on V6 and R/T models, Dodge adds a flat-bottom steering wheel and embroidered floor mats as a part of the package. Scroll down for the full press release for these commemorative models.

SRT reveals Satin Vapor Edition 300, Charger and Challenger SRT models

With the exception of some notable truck and van introductions, Chrysler brands have tended to use the Chicago Auto Show to bring out new special editions, pimp their aftermarket parts support or indulge in the occasional flight of fancy. That plan is holding true for 2014, as well. Cases in point are these new Satin Vapor Editions of the 2014-model-year Dodge Challenger, Dodge Charger and Chrysler 300 - all from SRT.
The Satin Vapor name may sound like a failed 1970s glam-rock band, or a pseudo-gynecological diagnosis from the Old West, but is, in fact, pretty much a tape-and-trim package for this trio of hi-po Mopars. 300, Challenger and Charger alike come shod with 20-inch aluminum wheels finished in Black Satin Vapor Chrome, and are accented with Satin Black bits aplenty. The 300 gets blacked-out mirrors, spoiler and roof; the Challenger applies it to mirrors and its fuel door; while the Charger has the stuff covering its roof, hood and Super Bee tail graphic.
Interiors of the cars have been mildly updated as well, with all three getting some combination of Nappa leather, ultra-suede and carbon-fiberish finishes.