Dodge Sprinter 2500, 2004 on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Stellantis pledges $2.8 billion investment in Canadian plants

Stellantis has re-upped its commitment to two pivotal Canadian factories. The Brampton Assembly Plant, where the Chrysler 300, Dodge Charger and Dodge Challenger are built, and the Windsor Assembly Plant, where the Chrysler Pacifica minivan is made, will receive a $2.8 million investment in the coming years.  The announcement came as welcome news for Brampton, as the plant's future was very much in doubt. The company had only promised to build the three models, sharing an aged platform, through 2023. Now the future is more clear. Stellantis will begin retooling the facility in 2024 once production of the muscle car trio winds down. When it comes back online in 2025, it will produce "at least one all-new electric model". It will also serve as the production facility for an all-new flexible architecture, but which models it will support were not disclosed. As for Windsor, retooling will begin in 2023. Stellantis didn't say when it would finish, but that it would be home to a "new multi-energy vehicle (MEV) architecture that will provide battery-electric (BEV) capability for multiple models." Both plants are expected to return to a three-shift schedule after layoffs at the plants dropped them down to two shifts. The reaffirmation of investment in Canada follows last month's announcement that Stellantis and LG Energy Solution would establish a $4.1 billion joint venture to make battery packs for electric vehicles. The project is being billed as Canada's first large-scale lithium-ion battery plant. In addition, Windsor's Automotive Research and Development Centre (ARDC) will now become North America's first battery lab. Stellantis is expanding the site by 100,000 square feet, where engineers will conduct R&D into BEV, PHEV and HEV cells, modules and battery packs. Stellantis North America Chief Operating Officer Mark Stewart said, "These investments reaffirm our long-term commitment to Canada and represent an important step as we move toward zero-emission vehicles that deliver on our customers’ desire for innovative, clean, safe and affordable mobility.”  Related video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.

2015 Dodge Charger darts into NY traffic

Meet the refreshed 2015 Dodge Charger; notice anything different? You would have to be pretty farsighted to miss the sedan's new Dart-like nose, and it's likely going to be quite polarizing to the car's fans. Gone are the previous furrowed, aggressive headlights in favor of a wider, friendlier look.
While the more rounded headlights and narrower grille are going to be the first thing most people notice, Dodge claims its designers have made changes to nearly every panel on the Charger. The hood dips down deeper at the front, and the doors show off a more angled version of the car's shoulder blister. LED running lights and taillights are standard on all models, and SXT and RT trims get LED foglights. Even though the front might not be as intimidating, Dodge has hung onto the sedan's muscular stance with angular contours making up the rest of the redesign.
Under the hood is the same engine range you've come to know over recent years. Both the 5.7-liter V8 and the 3.6-liter V6 return for 2015, with the Hemi making 370 horsepower and 395 pound-feet of torque, and the standard Pentestar outputting 292 hp and 260 lb-ft. All models are now equipped with Chrysler's TorqueFlight eight-speed automatic as standard. Fuel economy for V8 Chargers is predicted at 16 miles per gallon city and 25 mpg highway, compared to 15 mpg / 25 mpg last year with a five-speed automatic. All models also come with electric power steering, and the axles are cast from aluminum to save weight.