2004 Dodge Ram 3500 Slt Crew Cab Dually 5.9l Diesel Engine on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Takata airbag recall claims 209k Chrysler, Dodge vehicles

Chrysler is expanding the scope of its front passenger side Takata airbag inflator recall yet again to include 139,115 additional vehicles for a total of 208,783 units now needing these parts replaced. The latest campaign affects the passenger side inflators of the 2003-2005 Dodge Ram 1500, 2003-2005 Dodge Ram 2500, 2003-2005 Dodge Ram 3500, 2004-2005 Durango; 2005 Dakota pickup; 2005 Dodge Magnum and 2005 Chrysler 300 (pictured above), 300C and SRT8. It's limited to vehicles purchased or ever registered in Alabama, Florida, Georgia, Hawaii, Louisiana, Mississippi, Texas and the territories of American Samoa, Guam, Puerto Rico, Saipan and the US Virgin Islands. The company expects owners to be notified by February 8. The automaker just expanded the replacement campaign last week to include passenger side inflators in 149,150 pickups from the 2003 model year. However, the parts are not the same. Chrysler says this recall is for the PSPI family of components versus SPI for the last one. The company is also not aware of any injuries or accidents in its vehicles from these potentially faulty inflators, and lab testing of 600 of them finds no issues. Despite this, Chrysler is repairing these models at the request of the National Highway Traffic Safety Administration. Scroll down to read the company's full announcement of the initiative. Statement: Air-bag Inflator (Regional Field Action Expansion) December 12, 2014 , Auburn Hills, Mich. - Chrysler Group is expanding an ongoing regional field action with a recall to replace front passenger-side air-bag inflators in an estimated 208,783 older-model vehicles originally purchased or ever registered in seven U.S. states and five territories. The vehicles are equipped with front passenger-side air-bag inflators from a product family code-named "PSPI." Chrysler Group is unaware of any injuries or accidents involving PSPI inflators of the type covered by this campaign, nor has a Chrysler Group investigation identified a defect in these components. Further, laboratory tests on nearly 600 such inflators did not result in any failures. The inflators affected by this campaign differ in design and construction from PSPI inflators used by other auto makers. They also benefited from a more robust manufacturing process. However, at the request of the National Highway Traffic Safety Administration (NHTSA), Chrysler Group is expanding its replacement action beyond its original scope of Florida, Hawaii, Puerto Rico and the U.S.

Turn up the volume: Flat out in the Dodge Charger Scat Pack

The 2019 Dodge Charger R/T Scat Pack is a rare breed in the car market. It's a reasonably affordable large sedan with a huge honking V8 and rear wheel drive. You know, the perfect car for this Fourth of July. Or any day ending in Y, really. The R/T Scat Pack is the second most powerful version of the sedan with a 6.4-liter naturally aspirated V8 making 485 horsepower and 475 pound-feet of torque. Only the 707-horsepower Hellcat is a more powerful Charger. But power is only part of the story. The other part is the noise. The V8 has a gritty, dirty rumble to it. We recorded it cruising up on-ramps, down shifting, and got a few standing revs out of it. Check out the video to hear for yourself.