2004 Dodge Ram 3500 Diesel 4x4 Dually Laramie Heated Leather Quad 1 Texas Owner on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Mopar Hellephant is sold out, but here are 4 other awesome crate V8s to try

Despite a relatively enormous $30,000 price tag, Mopar's 1,000-horsepower supercharged Hellephant crate engine sold out in just 48 hours. Some enthusiasts may have missed out on the crazy engine due to lack of funds, or they just assumed there would still be some Hellephants down the line. But worry not, swap-happy gearheads. There are plenty of V8s in the world to pick from, and we highlighted four favorites. They're not as powerful, but they're all cheaper, and still have a lot to offer. Mopar 6.2L Hellcrate Odds are a lot of prospective Hellephant buyers were Mopar fans to begin with, so we'll start the list with the next-most-potent offering: the Hellcrate. This is the same supercharged 6.2-liter V8 found under the hood of the Dodge Charger and Challenger Hellcats and the Grand Cherokee Trackhawk. It makes 707 horsepower and 650 pound-feet of torque like those cars, too. It's also about $10,000 cheaper than the Hellephant engine at $20,020, and that leftover money can be used to finish the project or for aftermarket upgrades to get it closer to the Hellephant's output. GM LS9 6.2L The Hellcrate isn't the only factory supercharged crate engine on the market. From General Motors comes the supercharged 6.2-liter LS9 V8. This is the engine that was used in the C6 Corvette ZR1. At 638 horsepower and 604 pound-feet of torque, it doesn't make as much power or torque as the Hellcrate. But it does boast a dry sump oil system. So instead of pumping oil out of a pan at the bottom, the engine uses an oil tank mounted remotely that pumps oil into the engine. This means the engine is shorter overall, and can be mounted lower for a better center of gravity. It also means that there's almost no risk of running the engine dry in hard cornering, as could happen with a normal oil sump where the oil can slosh to the side without the oil pump. Basically, it offers some major benefits if you want supercharged V8 power for a road course car. It's also a tad cheaper than the Hellcrate at $18,149. But get one while you can, because GM is only selling what's left from when it was building the C6 ZR1. Ford Aluminator 5.2XS Our pick from the Blue Oval lacks a supercharger, but it's still pretty sweet.

2019 Dodge Challenger R/T Scat Pack 1320 gets race-focused upgrades

The Dodge Challenger SRT Demon is one hell of a machine. It's a single-minded 840-horsepower jackhammer, meant solely to burn rubber and win drag races. It's packed with all sorts of goodies like a transbrake, line lock, and a torque reserve mode. Still, it was an extremely limited-production model. It's also sold out. What do you do if you want some fun on the drag strip and you can't find our don't need the power of a Demon? Buy the new 2019 Dodge Challenger R/T Scat Pack 1320. You can really think of the Scat Pack 1320 as a Demon without the wide bodywork and the supercharged 6.2-liter V8. Instead, you'll find Dodge's tried-and-true 6.4-liter naturally-aspirated V8 under the hood making 485 horsepower and 475 pound-feet of torque. The TorqueFlite 8HP70 eight-speed automatic is the only available transmission. It's required equipment to use the TransBrake and Torque Reserve system. All-four wheels are wrapped in Nexen SUR4G Drag Spec 275/40R20 street-legal drag radial tires. The 1320 names comes from the length of a quarter-mile drag strip — 1,320 feet. The Scat Pack 1320 can run the quarter-mile in 11.7 seconds at 115 mph and hits 60 mph in just 3.8 seconds. Of course, that's in its lightest configuration. Like the Demon, the Scat Pack 1320 only comes with a driver's seat. The passenger and rear seats are each $1 options. The goal was to give grassroots racers a bare-bones performance car at a relatively reasonable price. You don't need passengers if you're only racing. You also shave 114 pounds from the car's curb weight. Other upgrades include an SRT-tuned suspension, a 3.09 rear axle ratio, 41-spline rear half-shafts, 20 x 9.5-inch aluminum-forged wheels with knurled bead seats (to keep the tires from slipping on the rim) and upgraded Brembo brakes with four-piston calipers. The Challenger R/T Scat Pack 1320 joins a number of other upgraded 2019 Dodge models. That includes the Challenger SRT Hellcat Redeye and the upgraded 2019 Charger SRT Hellcat. The Scat Pack 1320 adds $3,995 to the Challenger R/T Scat Pack's base MSRP. That's not the whole story. Since the automatic is mandatory, you need to tack on another $1,595. Add in destination, and the Scat Pack 1320 will set you back at least $45,980. Cars will hit dealer lots early next year. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.