2003 Dodge Ram 3500 Quad St Rwd 5,9l Cummins on 2040-cars

Auto blog

How to turn a Dodge airport tug into a trail slayer

Sometimes, having a ton of fun requires takes a ton of work. Just nine days before the so-called Ultimate Adventure 2014, the folks behind 4-Wheel & Off-Road had 40 tasks to complete in order to turn the ratty truck pictured above into a machine that could excel on treacherous off-road trails while still being able to handle highway jaunts. Much of process behind the build was chronicled on the latest episode of Dirt Every Day.
The team's vehicle started life as a 1990 Dodge tug truck that spent part of its life hauling around airplanes. The builders hung on to the Cummins six-cylinder diesel, but they tossed out practically everything else for the project, with some seriously heavy-duty replacement parts for the transmission, transfer case, axles and a whole lot more. The process was certainly a ton of work, but the end result looks like a fantastic crawler.
Sure, it might have been easier to bring a truck that was already prepared, but where would the fun in that have been? Stay tuned until the end of the video for a few glimpses of the completed Dodge and peek at some of the punishment it goes through.

Dodge Viper recall requires small-handed mechanics

It has been over a year since Chrysler first announced its recall of 3,660 2003-2004 Dodge Vipers because the airbag could suddenly deploy. The repairs are finally beginning, and it appears to be a nightmare for mechanics.
According to the automaker's filing with the National Highway Traffic Safety Administration, the airbag control module can fail, which causes the bag or the seatbelt pre-tensioner to deploy without warning. It took over a year to design the new parts, according to The New York Times. However, Chrysler finally has a new "jumper harness with an in-line diode filter circuit" ready to fix the problem.
The dilemma now moves to the mechanics who have to actually install the part. A 47-step guide from Chrysler explains that the procedure should take about two hours. It's not an easy job, though. Most of the dashboard has to be taken apart, and the instructions include this helpful bit of advice: "Installing the jumper harness and filter box into position is not an easy task. Patience, perseverance, and small hands are required." We wish the best of luck to them. The fix comes just in time for the Vipers to enjoy the summer sun.

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.