2000 Dodge 3500 4x4 Low Mile Cummins 5 Speed Manual on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

All-wheel-drive Dodge Challenger GT confirmed by EPA website

The US Environmental Protection Agency accidentally confirmed the upcoming Dodge Challenger GT by posting fuel economy figures for the all-wheel-drive variant of the muscle car. According to FuelEconomy.gov, the Challenger GT, which will come with the 3.6-liter V6 when it's released, is rated to get 18 miles per gallon in the city and 27 miles per gallon on the highway, giving the vehicle a combined rating of 21 miles per gallon. Those figures are slightly lower than the rear-wheel-drive Challenger with the same engine, which gets 19 miles per gallon in the city and 30 miles per gallon on the highway. While previous reports indicated that Dodge is planning to release the all-wheel-drive Challenger GT sometime in 2017, the automaker hasn't confirmed the vehicle. (Mopar's all-wheel-drive concept from last year's SEMA Show is pictured above.) With the EPA putting out the car's official fuel economy figures, the all-wheel-drive muscle car is definitely coming, and should be here before the entire Challenger lineup gets its expected redesign in 2018. And yes, we're still hopeful that the so-called Challenger ADR we saw in spy photos means we'll see all wheel drive and Hellcat power. Because Hellcat everything. Related Video:

FCA's UAW workers to get $8,010 profit-sharing payout

UAW workers at FCA will soon be receiving $8,010 checks, which represent profit-sharing based on the company's 2020 performance. Although FCA's profit margins in 2020 were slimmer than the year prior, the union-employee payouts are slightly larger, due to a change in the formula that was negotiated in 2019 and has now gone into effect. Employees are now paid $900 for every 1% of profit margin FCA achieves in its North American operations. For 2020, the company enjoyed an 8.9% profit margin, and although that was down slightly from 9.1% in 2019, the checks are larger than last year's $7,280 payout. Still, FCA employees didn't fare quite as well as their counterparts at GM, who stand to receive profit-sharing checks of up to $9,000. GM workers did even better last year, netting $10,000. UAW workers at Ford had less to celebrate. They'll receive $3,525, based on the company's 2020 performance. That's a steep drop from last year's $6,600. FCA earned $6.472 billion in North America in 2020. The company is expecting an improved financial performance in 2021, as it's expected to avoid another coronavirus-related shutdown. It's also expected to benefit from the launch of the three-row Grand Cherokee L, as well as the Jeep Wagoneer and Grand Wagoneer, all of which are high-margin products. Related video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.