Slt, Crew Cab 4dr, Short Box, Cummins Turbo Diesel, Loaded And Clean, Warranty ! on 2040-cars

Auto blog

2020 Dodge Challenger Drag Pak will debut at SEMA

Mopar fans have countless reasons to get hyped about the 2019 SEMA show. Speedkore is bringing a twin-turbocharged, all-wheel-drive Dodge Charger Hellcat Widebody, Mopar is bringing a done-up 1968 Dodge D200 "Lowliner," Ram is bringing a diesel 1500 overlander, and Jeep is bringing a custom off-road Wrangler. But the launch of the new 2020 Dodge Challenger Drag Pak might garner the most attention from the brand's most serious customers. Prior to the show, Mopar teased a photo and a short video clip, both showing a new Dodge Challenger from the overhead view. The white Challenger showed a wide blue stripe down the center of the car with two pinstripes along each side. "Powered by SRT" runs across the top of the windshield, and Mopar logos grace both sides of the car just beneath the side windows. Red decals run back from the rear quarter panels and connect across the rear of the car. It also has hood pins on the SRT Hellcat hood and a parachute attached the rear. There's a parachute because this is the factory turnkey drag-race-focused Dodge Challenger racecar. Mopar released no other information on what type of hardware the Drag Pak will be using, or what's under the hood, but the video gives a great preview of the exhaust note in full tire-smoke mode. As some Drag Paks in the past have dropped roughly 1,000 pounds from their production starter vehicles, the 2020 model will surely utilize plenty of weight-savings methods such as the removal of all interior comfort features that don't apply on the racetrack. Mopar has also previously altered the position of the engine and changed the wheelbase to the benefit of better weight distribution. Mopar is set to livestream the unveiling starting at 7:26 p.m. ET (that's 4:26 on the West Coast, which not coincidentally coincides the the displacement of the vintage 426 Hemi engine) on Nov. 5, 2019. Until then, check out the 2009, 2010, 2011, or 2016 Drag Paks.

FCA CEO Mike Manley will take undefined new role after PSA merger

MILAN — Fiat Chrysler Chief Executive Mike Manley will remain with the new group set to result from a planned merger with French rival PSA-Peugeot, Chairman John Elkann said on Wednesday. In a letter to Fiat Chrysler (FCA) employees on the day the two companies announced a binding agreement for a $50 billion tie-up to create the world's fourth-largest carmaker, Elkann said he was "delighted" that the combined group would be led by current PSA CEO Carlos Tavares. "And Mike Manley, who has led FCA with huge energy, commitment and success over the past year, will be there alongside him," he said. He did not say what position Manley would hold. Elkann — who will chair the new group — said there was still much to be done to complete the merger. "Over the coming months we must work tirelessly and determinedly to fulfill all the approval requirements needed to finalize the commitment we have signed," he said. Related Video:     Hirings/Firings/Layoffs Chrysler Dodge Fiat Jeep RAM Citroen Peugeot FCA PSA merger Mike Manley carlos tavares

Chrysler recalls small number of 2013-2014 cars and trucks over engine debris

Chrysler is recalling a small number cars over issues with their 2.4-liter four-cylinder engines. The recall, which affects 522 examples of its 2013 Dodge Avenger and Chrysler 200 models, as well as 2014 Jeep Compass and Patriot CUVs has to do with potential debris in the balance shaft bearings.
The abrasive stuff can cause the oil pressure to drop, which could lead to the engine stalling or outright failure. This situation could at best leave drivers stranded and at worst lead to a crash.
Chrysler will begin notifying owners, who will need to report in to have the balance shaft module replaced. All repairs are naturally free of charge. Scroll down for the bulletin from NHTSA.