2001 Dodge Ram 2500 Extended Cab V10 Gas Motor 69000 Org Miles on 2040-cars

Auto blog

470,000 Jeep Liberty, Chrysler 200, and Dodge Avenger models recalled for restraint defect

Fiat Chrysler Automobiles said on Friday it is recalling 470,000 vehicles worldwide to replace a component that may inhibit deployment of the vehicles' active head restraints in the event of a crash. Around 414,000 of those vehicles were sold in the United States. Apparently, "a component common to the modules of certain vehicles may degrade after extensive vehicle use." The recall covers 2012 Jeep Liberty sport utility vehicles and 2012-13 Chrysler 200 and Dodge Avenger midsize cars. FCA says a warning light may alert owners to the problem. The Italian-American automaker said it is unaware of any injuries or accidents related to the recall. The U.S. National Highway Traffic Safety Administration opened an investigation into the issue in June. (Reporting by David Shepardson; Editing by Steve Orlofsky) Related Video:

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler recalls 350k vehicles over ignition switches

Chrysler has announced a recall covering 349,442 vehicles due to ignition switches that can either become stuck or move without warning. All of the affected vehicles are from the 2008 model year, and were built before May 12, 2008.
The automaker has learned that ignition keys on some vehicles "may not fully return to the 'ON' position after rotation to the 'START' position during engine-startup," the company said in a statement. Additionally, "an ignition key may not fully return to the 'ON' position after rotation to the 'START' position and may inadvertently move through the 'ON' position to 'ACCESSORY' or 'OFF.'"
Chrysler says it is unaware of any related injuries, and notes that while reduced braking, engine or steering power is possible in such instances, the airbags are not affected. The later stands in contrast to General Motors' recent rash of high-profile recalls, and it's an important distinction that Chrysler (understandably) felt necessary to call out in bold print in its press release.