1997 Dodge Ram 2500 12 Valve Cummins Diesel 4x4 on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

2018 Dodge Challenger SRT Demon First Drive | Don’t fear the Demon

"If you're not hurt, we'll be really pissed. If you are hurt, we'll still be pissed, but not quite as pissed." These are the words from Jim Wilder, the vehicle development manager of the 2018 Dodge Challenger SRT Demon, that echo through our head as we slide behind the wheel of the car for the first time. He was warning us about driving beyond our abilities, and keeping the car out of the wall. With 840 horsepower and 770 pound-feet of torque on tap from its supercharged, 6.7-liter V8, the Demon does 0-60 miles per hour in 2.3 seconds, and 0-30 mph in a second flat. If something does go wrong, it'll happen quickly. Following that talk, we had our guts sloshed as a passenger in a blurry eighth-mile run, giving us a taste of the G forces (the Demon can pull 1.8 G in a straight line) we'd feel when we got in the driver's seat for our own pass down the drag strip. We're already sweating. It had rained - you could describe it as torrential - the day before. The grassy parking areas surrounding Lucas Oil Raceway were still flooded, but any water on the pavement had evaporated and hung in the air. Combined with the heat, we were sticky and uncomfortable. In Drag Mode, the Dodge Demon's air conditioning turns off. Any condensation that it could leave on the track would be a problem, plus we need to reduce parasitic power losses for a faster run. The system is still working, though, the refrigerant diverted to the chiller system cooling the air coming into the engine. There's still condensation, but the Demon collects it on a catch pad to keep it from ending up on the pavement. We're also required to roll the windows up when entering the drag strip. For one thing, it helps keep the smoke out of the cabin during the pre-staging burnout. So, yeah, it's hot as Hell in the Demon. We pull through the water box and run through the sequence – which involves holding the "OK" button on the steering wheel usually used to navigate menus, and applying a specific amount of brake pressure before getting on the throttle to initiate the burnout. This gets any crud off the rear tires and heats up the rubber. There are multiple ways to launch the Demon. We had an instructor sitting in the passenger seat as we pulled up to the beams that trigger the Christmas tree at Lucas Oil Raceway. He walks us through the most complicated of the three he had explained to us just minutes before when we were in the passenger seat.

Junkyard Gem: 1986 Dodge Ram 50

After years of selling the Isuzu Faster with Chevrolet LUV badges here, GM replaced it with the S-10 in 1982. Ford sold Mazda Proceeds with Courier badges for even more years, but ditched the Courier once the Ranger became available as a 1983 model. Chrysler was able to put truck beds on Omnirizons at that time, but didn't have the deep pockets to develop its own rear-wheel-drive small pickup; for this reason, Dodge-badged Mitsubishi Forte pickups continued to be available in the United States all the way through the 1994 model year. Here's one of those trucks, found in a Colorado car graveyard. The first Chrysler-imported Mitsubishi Fortes showed up in the United States as 1979 models. The Dodge-badged version was known as the D-50, while Plymouth dealers got theirs with Arrow badges. The Dodge D-50 became the Ram 50 for the 1981 model year, while the final Plymouth Arrow trucks were sold as 1982 models. Just to make things more interesting, Mitsubishi started selling its own vehicles in the United States beginning with the 1983 model year. That meant that the Ram 50 had to compete for sales with a near-identical twin sporting Mitsubishi badges. Things in the Chrysler-Mitsubishi universe got even more exciting a bit later, when there were four marques selling essentially the same car here simultaneously: the Mitsubishi Mirage, Plymouth Colt, Dodge Colt and Eagle Summit. All of the Dodge D-50s and Ram 50s came with Mitsubishi power under their hoods. This one has a 2.0-liter SOHC straight-four rated at 88 horsepower and 108 pound-feet. For a while, a 2.3-liter Mitsubishi diesel was available in the Ram 50. It had been discontinued by 1986, however. This one has the base five-speed manual transmission. It appears that this truck was being used for long-term storage of many, many boxes of random household stuff when it was banished to this place. Much of the stuff was scattered on the ground nearby. Perhaps it was parked at a rent-a-storage facility and got evicted for lack of rent payments. Much of the contents consisted of stacks of newspapers and magazines from the 1960s and 1970s. Here's an Art Buchwald column about then-Vice President Spiro Agnew from February 23, 1971. Here's a Beetle Bailey strip from the same year. There's plenty of history in the junkyard, if you know where to look. There must have been a half-ton of paper in this truck when it arrived here. Sadly, some family's photo albums were here as well.