One Owner Rumble Bee Second Swarm 4x4 Spotless Clean! Bluetooth! Tons Of Extras! on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler recalls small number of 2013-2014 cars and trucks over engine debris

Chrysler is recalling a small number cars over issues with their 2.4-liter four-cylinder engines. The recall, which affects 522 examples of its 2013 Dodge Avenger and Chrysler 200 models, as well as 2014 Jeep Compass and Patriot CUVs has to do with potential debris in the balance shaft bearings.
The abrasive stuff can cause the oil pressure to drop, which could lead to the engine stalling or outright failure. This situation could at best leave drivers stranded and at worst lead to a crash.
Chrysler will begin notifying owners, who will need to report in to have the balance shaft module replaced. All repairs are naturally free of charge. Scroll down for the bulletin from NHTSA.

2015 Dodge Challenger SRT Hellcat with '600-plus horsepower' officially unveiled [w/video]

Dodge has officially unveiled the most powerful vehicle to ever wear the Challenger name - the SRT Hellcat - complete with over 600 horsepower courtesy of a supercharged, 6.2-liter Hemi V8. It will be offered alongside the 485-hp Challenger SRT.
The new, force-induced V8 isn't just the most powerful ever fitted to the Challenger, it's the most powerful eight-cylinder Chrysler Group has ever built. Power figures aren't finalized, so expect to see "over 600 hp" bandied about quite a lot. That fury will be channeled through either a six-speed manual or eight-speed automatic. Yes, over 600 ponies through an eight-speed auto. So far, the only vehicle we know of that delivers more output through that many gears is the as-yet untested Chevrolet Corvette Z06. Sadly, we don't have performance metrics just yet, although if this thing can't crack four seconds to 60 miles per hour, we'll be pretty surprised.
As is the theme nowadays, the 2015 Challenger SRT features a number of driving modes, governing power output, shift speeds for the 8AT, steering effort, traction control settings and suspension settings. There are three pre-programmed options - Default, Sport and Track - and a Custom mode that allows drivers to mix and match to their heart's content.