2007 Dodge on 2040-cars

Auto blog

Dodge engineers trying to shoehorn Pentastar into Dart?

The fact that the Dart's launch has been a pretty dismal affair isn't what we'd call secret. Judging by its mounting inventories and poor critical reception, Dodge's successor to its unloved Caliber has struggled since it hit the market. And while both of those are difficult problems to address, at least their cause is well known - the powertrain.
Even Fiat-Chrysler CEO Sergio Marchionne has acknowledged that the powertrain options in the Dart are substandard, admitting at January's Detroit Auto Show that the powertrains are "less than ideal." Leading with the 1.4-liter turbocharged four-cylinder found in the Fiat 500 Abarth left a bad taste in the mouths of consumers thanks to the laggy engine and dead throttle response (to say nothing of the manual and dual-clutch gearboxes that needed more refinement). The addition of the 184-horsepower 2.4-liter Tigershark in the Dart GT has helped matters some, but apparently Auburn Hills doesn't think it's quite enough.
If rumors are to be believed - get that salt ready - a possible solution may be in the works. A report from Allpar is claiming that Dodge is considering fitting a Pentastar V6 into the Dart's engine bay. As the Mopar-obsessed website points out, the critically acclaimed Pentastar is available in three different sizes - 3.0 liters, 3.2 liters and the original 3.6 liters. We don't get the 3.0 here in the US, but the 3.2 can be found in the new Jeep Cherokee and the 3.6 has been seemingly fitted to every model Chrysler can shoehorn it into.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge Challenger SRT Hellcat's 707 storming horses can be yours for $60k

We love a good deal on high performance. It's what traditionally makes muscle cars so appealing - you get lots of speed, for not a lot of money. For 2015, Dodge has taken this to its logical extreme, offering its new 707-horsepower, supercharged, V8-powered Dodge Challenger SRT Hellcat for just $59,900. For those wondering, that works out to just about $85 per horsepower, which when compared with a typical budget performance car, like the $24,995, 210-hp Volkswagen GTI ($119 per hp), demonstrates the Hellcat's astonishing value.
The information was revealed by a photo (click on the inset image to expand) taken at this week's Portland launch event (our man Seyth Miersma is just now on the ground and will have a full report on the madness that is the Hellcat soon) for the entire 2015 Challenger range, and reveals the Hellcat's price alongside its high-powered competitors from Ford and Chevrolet.
The discontinued 662-hp Mustang GT500 started at $56,000, while the 580-hp Camaro ZL1 starts off at $58K. Indeed, the only muscle car that outprices the Hellcat is the track-focused Camaro Z/28, a car that we're guessing could still wallop the Hellcat on the right piece of track, despite being down over 200 hp.