2003 Dodge Ram Quad Cab 1500 5.7 Hemi Clear Title on 2040-cars

Auto blog

Chrysler recalling over 200k vehicles across its brands

With more than 200,000 units across six separate recalls and almost all of its brands, it appears that Chrysler has officially jumped headfirst into the recall pool this month. The National Highway Traffic Safety Administration has issued three official recalls for the automaker, and The Detroit News is reporting that the automaker itself has announced three more.
The biggest of the recalls applies to about 120,000 Dodge Charger, Dodge Challenger and Chrysler 300 models for 2011 and 2012 due to faulty wiring harnesses for the seat-mounted side airbags, which could lead to these airbags not deploying in the event of a crash. A little more than 60,000 two-wheel-drive versions of the 2007-2008 Dodge Nitro and 2008 Jeep Liberty SUVs are being recalled due to a heat shield that could cause the driveshaft to break, which if that isn't bad on its own, could then hit underneath where the airbag sensor is mounted, causing the airbags to deploy. Wrapping up NHTSA's recall notices, about 20,000 Jeep Patriot and Jeep Compass models for 2012 are also being recalled due to a problem with the fuel tank transfer tube that could lead to the vehicle stalling. The LX car recall campaign is going into effect this month, while the other two will start next month - all three notices are posted below.
In addition to the official NHTSA recalls, The Detroit News is also reporting that Chrysler is recalling more than 16,000 Ram trucks and a small number of Dodge Dart sedans. Around 6,500 2013 Ram 1500 trucks will be recalled due to an improper adjustment of the parking brake cable from the factory, while 7,000 Cummins-powered 2013 Ram Heavy Duty trucks are being recalled due to an engine cover that does not have as much heat resistance as it is supposed to. Finally, a total of 46 Dodge Dart sedans are being recalled due to a problem with the brake calipers and/or parking brake.

All hail the Hellephant, Mopar's 1,000-horsepower crate engine

It's shocking to say this, but the all-powerful Dodge Demon looks weak now that Mopar has unleashed the Hellephant. This crate motor makes 1,000 horsepower and 950 pound-feet of torque, and its name is a combination of the nickname for the old 426-cubic-inch Hemi V8 and, obviously, the Hellcat. This monster is a 426-cubic-inch version of the current third-generation Hemi V8 topped by a supercharger similar to what the Hellcat line packs. Everything is cranked up to — or perhaps, past — 11. The engine block is made of aluminum and weighs 100 pounds less than the equivalent iron block. All of the internals are forged. The stroke and bore have been increased. The supercharger produces 15 pounds of boost and displaces 3 liters; more than the 2.7-liter blower on the Demon and the 2.4-liter blower on the Hellcat. And as big and powerful as it is, it will still rev to 7,000 rpm. It's a thoroughly monstrous motor, but shockingly, it won't be that difficult to live with. For one thing, Mopar will offer a complete kit to get the engine up and running, including an engine computer, wiring harness and drive-by-wire throttle. It also runs on 93-octane pump gas. That's especially amazing considering the Demon engine "only" makes 840 horsepower, and that's on race gas with 100+ octane fuel. It also has us wondering what the Hellephant could make on racing fuel. The Mopar folks did say that there's room to add more power. Pricing wasn't announced for the Hellephant engine. The Hellcat crate engine retails at $19,350 directly from Mopar, so it's safe to assume that the Hellephant will go for more. The installation kit with the computer and harness will be an extra charge of likely over $2,000, based on the Hellcat kit. The engine and the kit will be available in the first quarter of 2019. Related Video: Featured Gallery Hellephant Crate Engine SEMA Show Chrysler Dodge Jeep RAM Performance dodge demon hellephant

Inline-6 Hemi replacement on the cusp of production from Stellantis

It appears that Stellantis is ready to put its long-rumored inline-six into production at its Saltillo, Mexico plant, possibly marking the beginning of the end of Chrysler's long-running 5.7L Hemi V8. But so far, the automaker's American brands have remained mum on where exactly the new turbocharged "Tornado" I6 may land. Stellantis powertrain blog Stellpower (by way of Muscle Cars & Trucks) spotted an entry for a new "GME T6" inline-six engine on the Saltillo facility's web site, suggesting that it was either in production or close to it. That entry has since been removed, but the mystery remains.  We've been hearing tidbits here and there about this new inline engine for years, but this is the first time we've seen anything suggesting its arrival is imminent. Usually, such a significant powertrain update would coincide with the launch of a new product to showcase it. So far, Stellantis has remained mum, even overseas, about where this engine is destined to reside. 2022 model year vehicles are likely off the table entirely.  But while it's common for new engines to debut with new cars and trucks, it's not a universal truth. Ford's Coyote V8 missed the corresponding Mustang refresh by a year, for example, orphaning the 2010 model and its much-needed styling updates with the old 4.6L V8 (and the 3.8L V6, for that matter; the 3.7L Duratec was also late to that party). Even sticking just to Stellantis, the JL Wrangler's powertrains have been a work in progress since it arrived back in 2018. The standard V6 and 2.0-liter turbo-4 debuted at launch; the EcoDiesel, 392 and 4xe all came later.  And 4xe may be the model by which to measure our expectations. Its introduction didn't come completely out of nowhere, but it was rather sudden for what turned out to be such a solid offering. That bodes well for the company's existing Hemi-powered trucks and SUVs. The Ram 1500, Jeep Grand Cherokee and Wagoneer are all strong candidates to receive the new Hemi replacement, as all would greatly benefit from even small improvements in fuel economy. If there's to be a future for the Dodge Charger and Challenger and Chrysler 300, they'd benefit too. And how about a Gladiator with the wick turned up, positioned as its equivalent to the Wrangler 392. Turn that Tornado into a Dust Devil. Don't worry; we've got plenty more where that came from.  Related Video This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.