2002 Dodge Ram 1500 Conversion Van 32k Actual Miles!! No Reserve!! 5.2l Loaded on 2040-cars

Auto blog

2.1 million vehicles recalled again over faulty airbags

Fiat Chrysler Automobiles, Honda and Toyota will recall 2.1 million vehicles to fix faulty airbag modules "after the manufacturers' original attempts to fix the defects proved ineffective in some vehicles." These vehicles had all previously been recalled, but the National Highway Traffic Safety Administration found that the airbags could still potentially malfunction. This recall will cover Acura MDX, Dodge Viper, Jeep Grand Cherokee, Honda Odyssey, Pontiac Vibe, Toyota Corolla, Toyota Matrix and Toyota Avalon models made in the early 2000s. NHTSA has reportedly received about 40 reports of airbag deployment in such vehicles, even though the vehicle had not been involved in a crash. Roughly one million of these same vehicles, all from Honda and Toyota, are also subject to recalls due to faulty Takata airbag modules, though this particular recall is for "an electronic component manufactured by TRW" that is separate from the actual airbags from Takata. According to NHTSA Administrator Mark Rosekind: "This is unfortunately a complicated issue for consumers, who may have to return to their dealer more than once. But this is an urgent safety issue, and all consumers with vehicles covered by the previous recalls should have that remedy installed. Even though it's a temporary solution until the new remedy is available, they and their families will be safer if they take the time to learn if their vehicle is covered and follow their manufacturers' instructions. A hassle is much better than a family tragedy." If you're the owner of an affected car, expect to hear more from the official automaker and government channels in short order. In the meantime, we'd suggest getting your car checked and fixed at your local dealer. The official statement and recall information can be found below. Previously Recalled Vehicle Remedies Not Working as Designed; NHTSA Announces Follow up Recall of 2.12 Million Cars and SUVs Saturday, January 31, 2015 Contact: Gordon Trowbridge, 202-366-9550, Public.Affairs@dot.gov WASHINGTON – U.S. Transportation Secretary Anthony Foxx announced today the recall of more than 2.12 million Acura, Dodge, Jeep, Honda, Pontiac, and Toyota vehicles for a defect that may cause airbags to deploy inadvertently. The recalls will provide vehicle owners with a new remedy after the manufacturers' original attempts to fix the defects proved ineffective in some vehicles.

Dodge Demon makes so much torque, it needs stronger driveline parts

Torque is a lovely thing, a sweet and wonderful force that twists and pulls and can help propel a two-ton metal box forward at comical speeds. Torque is also fickle and will bend and break those same metal parts without a second thought, which is why the new Dodge Demon is compensating for its increased torque with some new re-engineered and reinforced parts. And there's software intended to combat wheel hop, which one of the most dramatic ways torque can break stuff. Week 8's video, "Race-hardened Parts," gives a hint towards what all these new parts can do. While we still don't know how much torque the Demon will throw out, we do know it's enough to warrant an upgraded prop shaft, half shafts, and a differential housing. The Challenger Hellcat, which is the basis for the Demon, makes 650 pound-feet of torque already. The new parts will go a long way toward making sure the work from the Demon's engine is properly translated into motion by those Nitto drag radials. The new prop shaft uses high-strength steel, heat-treated stub-shafts, and increases the tube thickness by 20 percent for a 15 percent increase in torque capacity. Additionally, Dodge says the upgraded differential housing allows for a 30 percent increase in torque capacity by using heat-treated A383 aluminum alloy and a higher strength shot-peened gear set. The 41-spline half shafts that deliver 20 percent increased torque capacity through the use of high-strength low alloy steel and 8-ball joints. In addition to the hardware, the Launch Assist software has been tuned to help alleviate wheel hop. Dodge says the Demon is the first factory production car that uses wheel speed sensors to detect hop and momentarily cut torque to compensate. This means a driver can keep their foot planted on the floor while the computer sorts out the traction. Previously, the best solution was to back off the throttle to manually cut the load. Finally, the Dodge Demon will offer a four-point harness mounting bar as an optional accessory. The part will be supplied by Speedlogix and fits in place of the deleted rear seat. Customers can install the bar without having to hack apart their cars to find a proper mounting point. Look for more teasers and info on ifyouknowyouknow.com in the lead-up to the Demon's debut at the 2017 New York Auto Show. Related Video: Image Credit: FCA Dodge Performance dodge demon dodge hellcat

Chrysler recalling 780k minivans over fire risk

Chrysler is recalling 780,000 of its Town & Country and Dodge Grand Caravan minivans from the 2010 to 2014 model years due to the possibility of circuits overheating, which can lead to a fire. Of the 780,000 total vans being recalled, Chrysler estimates that 644,850 are in the US, 106,980 are in Canada, 8,009 are in Mexico, and 20,638 are in other markets. All of the affected vehicles were built between August 25, 2010 and October 31, 2013.
Chrysler's engineers discovered that beverage spills or exposure to moisture (from rain, snow, car washes, and the like) were linked to circuits shorting in the window switch assembly. Short circuits can overheat, and thus, cause a fire.
Chrysler will contact owners and let them know when they may schedule service, at which point, the window switches will be replaced. In the interim, the automaker says that owners may visit their dealers after May 14 to have the switches disconnected.