1999 Dodge Ram 1500 Club Cab on 2040-cars

Auto blog

Dodge Viper saved from crusher by students, but will it last?

The saga of the Washington state community college hoping to keep its allegedly pre-production Dodge Viper out of the maw of the crusher is going strong. Not only does the school still have the car, but there's a chance that the college might even get to keep it.
The whole situation flared up in March when the South Puget Sound Community College in Olympia, WA, received a notice from Chrysler Group that requested that the school's Viper be destroyed. The automaker had loaned the muscle car to it about a decade ago to use for educational purposes in its auto tech classes. With the Dodge growing long in the tooth, "it is unlikely that these vehicles offer any educational value to students," the company said in its press release on the matter.
However, the college balked at destroying its Viper, despite the fact it had signed a contract with Chrysler Group to do so. The school further claimed that its car was incredibly special because it was a pre-production example and just the fourth one made back in 1992. Although, as we pointed out at the time, the photos of the school's vehicle showed a coupe that looked like a newer Viper GTS.

2015 Dodge Challenger SRT Hellcat [w/videos]

Darrell Waltrip once said, "If the lion didn't bite the tamer every once in a while, it wouldn't be exciting." The sentiment behind that aphorism is causing my adrenal gland to wake up as Dodge and SRT drivers and engineers - somber-faced to a man - give me the track talk that will precede my driving the 2015 Dodge Challenger SRT on the circuit at Portland International Raceway. PIR might not be Daytona, and the 707-horsepower Challenger Hellcat might seem tame to a legend like ol' Jaws, but there's a not-small part of me that's thinking about how hard Dodge's fire-breathing kitty might bite.
Just a few hours previous, I'd gotten behind the wheel of the Hellcat for the first time, letting its hyperbole-spitting, supercharged V8 Hemi pull me yieldingly through Portland's morning commuter traffic. Lulled into a cocky certainty by the Challenger's good manners at low speed, I drove the throttle just a hair too deep, too fast when I ran on to the highway ramp. For just an instant the rear tires were utterly drenched in torque, and the back end of the big Dodge loosened up like a drift car on a wet track. Throttle steer lives at the fleeting whim of your right foot in this car.
It was no big thing to lay off the gas and pull the Hellcat back in line as I entered the highway, but the incident did get me to thinking: What will this car do to me on a road course?

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.