1996 Dodge Ram 1500 Base Extended Cab Pickup 2-door 5.2l 4x4 on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler recalling 67k trucks with manual transmissions

Earlier this month, Chrysler announced the recall of some 280,000 pickup trucks over concerns that their axles could seize up. Now the automaker has announced an entirely separate recall of another 66,819 trucks over the springs that could break in the clutch ignition interlock switch. The recall affects Dodge Ram 1500, 2500 and 3500 pickups, as well as the Dodge Dakota and Mitsubishi Raider. The issue is relevant only to those trucks fitted with manual transmissions, from the 2006 and 2007 model years and manufactured between July 1, 2005, and July 31, 2006. Since a broken spring could, according to statements issued by the National Highway Traffic Safety Administration and FCA US LLC (previously known as the Chrysler Group) prevent the vehicle from starting, or cause it to move unintentionally once the ignition kicks over, the automaker will begin notifying owners of the affected vehicles just before Valentine's Day to bring their trucks into their local dealers to have the clutch ignition interlock switch replaced. FCA emphasizes, however, that the unintended movement would only occur "in rare cases" and only "if recommended starting procedures are not followed." Only one such case is known to have occurred, but it did regrettably result in a fatality. Statement: Clutch Ignition Interlock Switch December 29, 2014 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary global recall of an estimated 66,819 older-model pickup trucks equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. An investigation by FCA US engineers discovered switches in certain model-year 2006 and 2007 pickups may be equipped with spring wire that differs from wire used in previous switches. The alternate wire may break and, as a result, the vehicles may not start. In rare cases, a vehicle may – if recommended starting procedures are not followed – exhibit unintended movement when its ignition key is turned. The Company is aware of one fatality related to this campaign. It stemmed from the single known accident involving this population of vehicles. The recall covers certain Dodge Dakota, Dodge Ram 1500, 2500, 3500 and Mitsubishi Raider pickups. Switches with the alternate wire were not used in any vehicles produced before July of 2005, or after June of 2006. The Dakota and Raider are no longer in production.

What does Jeep have cooking with this stretched Cherokee?

Chrysler has been spotted testing what appears to be a stretched Jeep Cherokee prototype. Which seems odd, considering that Jeep already makes a Grand Cherokee, and that's an entirely different model. The question then is just what the company has in the works here. We don't know for sure – but we do have some ideas. We're anticipating a new Grand Wagoneer to serve as the brand's flagship model, but stretching the Cherokee's wheelbase to leapfrog the Grand Cherokee's would take more than eight inches – and stretching a "compact" platform to get there wouldn't seem to make a lot of sense. Alternatively Jeep could be looking to wedge a new model into its lineup in between the Cherokee and Grand Cherokee, potentially offering a third row of seats and wearing the Wagoneer name - sans the "Grand" - as part of a new range of seven-seaters. Just what the point would be, however, when the Dodge Durango already offers three rows based on the same platform as the Grand Cherokee, is a bit of a mystery. Another possibility is that it's not a Jeep at all, but rather a Dodge. The brand is in need of a replacement for the current Journey, and we're also waiting to see what FCA does to replace the Grand Cherokee since it unveiled the Chrysler Pacifica to replace the Town and Country. More of a crossover approach could take the Cherokee's Compact US Wide (CUSW) platform as its starting point, but stretched like this prototype to offer more space. Whatever it is, we're sure this won't be the last we'll have seen of it, so watch this space. Related Video: